Stan C Aberdeen , WA January 18, 2017 Dishwasher was not draining good Replaced sump and related pieces. Also replaced door baffles that were getting bad. The hardest part of job was removing the dishwasher from the its spot in cabinets. The info on site made replacing parts easy. Read More... 10 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers
L B Garden City , GA October 06, 2017 Appliance: Model GE GSD1300N10BD Dishwasher would not empty the final rinse water. Replaced the part, a coupler.. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Rhonda D Tampa , FL October 11, 2015 Bacteria colony in drain! Ordered new parts and put them in! Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Vincent G Aliquippa , PA January 13, 2025 Water discharging into cabinet The water was coming out of the overflow into my cabinet not just into the drain. Turns out there was just debris in the drain little draino cleaned it out I took that opportunity to change the discharge hose and clean all the filters. I had the special order the little rubber coupler that had disintegrated and the large filter as it was so gross it wouldn't come clean. It was an easy repair just a little tough getting underneath the washer to change the hose. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Cathleen P Chicago , IL January 24, 2015 Appliance: General Electric Dishwasher GSD4060N10SS Rotted coupler in ge dishwasher After viewing a few videos on how to remove the spray arm and filter below it, removing and replacing the rotted coupler (part 450, attaching the filter to the spray arm base) was easy. Removing the spray arm required reaching around with a screwdriver to pop a lever on the back side of the spray arm to remove it, then unscrewing the filter and moving the lever the other way to wiggle it out. Then I popped off the rotten coupler, slid on the new one, and replaced the filter and spray arm. I replaced the silverware basket, too, since the one on our 7 year old washer was cracked. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers