Graeme M Branford , CT October 07, 2017 Appliance: Model GSD 940 Soap dispenser wouldn't close door kept falling down First replaced the latch, spring, and lever, but no improvement. Then I saw the lever arm on the other half of the door, which by position had to be the way that the timer interacts with the soap dispenser. After turning off the power to the dishwasher, I removed the switch cover (not obvious how -- a video would help: on the left, I slid the narrow rectangular plastic wire cover a little to one side and gently opened it on its little hinge, which is near the left side of the door, and then I was able to slide up and lift the plastic cover for the switch. I removed two screws from the top of the switch, and it lifted out. There I saw that the plastic arm had a spring dangling loose from its end that had been hidden under the switch cover. I also saw that there was a plastic post on the door that was supposed to anchor the loose end of the switch. Inspired by other advice on this site, I drilled a hole into the middle of the base for the broken post, using the narrowest drill bit that I have. I had to scrape away plastic curls melted from the drill, and then I gently but firmly inserted a 5/8-inch wedge nail that just fit in the hole, using my thumb. I didn't need the super glue that I'd thought, because the nail fit tightly. This is like a finishing nail, only it's got a bit of a flat head so that the spring can't slide off the end. I hooked the loose end of the spring into the nail, put back the switch and its cover, and closed up the door the same way that the video for replacing the soap dispenser latch showed. Working great! Took me a long time because of investigating, but if I'd worked the problem systematically and known how to disassemble the switch, probably 20 minutes would have been enough. Oh, and I also replaced the door spring. A video would be helpful for this, too. Used only a screwdriver, and it took about 30 minutes because I had to figure out how it was put together. By the way, this washer has two cables and two springs -- I recommend buying all four parts if you're going to get into the problem anyway. People on phone at AppliancePartsPros were patient and well-informed. I'll go back for future repairs. Read More... 30 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Screwdrivers
Robert A Stamford , CT March 28, 2021 Appliance: General Electric Dishwasher GSD650L-01 Rinse aid tank Replaced rinse aid tank,soap dispenser lever, detergent cup spring and cover detergent cup. Replacing all parts went smoothly. Problem resolved. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
Gerald B Muscle Shoals , AL January 09, 2022 Appliance: Hot Point Dishwasher HDA2000T00BB The soap dispenser lever and cup cover were missing. Water was running out on the floor. I did not know what was missing but the parts list on your website clearly showed what parts I needed. I ordered the missing parts, reviewed the video, and had little trouble in installing the new parts. In about an hour the total repair was completed. Without the parts list on the website, I would have had no idea what I needed. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers