Randy K Eureka , MT May 06, 2015 Oven did not heat Replaced control board after troubleshooting to find out the elements were ok Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Kell H Ruther Glen , VA September 10, 2019 No error codes convection fan ran all the time (even with oven off) Replaced control module...very easy to remove/replace. Just take off two screws on the back of the range to pull the control panel forward. Then, remove 4 screws that hold the control board to the panel. Then, make note of the wire connector locations (I used cell phone camera) and pull wires off of old control board. Then, installation was reverse of removal. Works perfectly now! Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
David B Mechanic Falls , ME February 17, 2022 Control board was dead I got the part from you and had my local appliance service people install it. You were the only source I could find for this part, apparently GE no longer makes them or supports the stove. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes