Barbara L Roanoke , VA January 05, 2019 End caps for oven door had broken and kept falling out Somewhat difficult to slide back on because pieces of the old tabs were stuck in the crevace, but once I realized and fished them out the next challenge was finally figuring out part went inside the crevace and part (a tab) went outside on the back of the handle. If you bend over and look up underneath it is easy to see how it goes, but apparently over the years the handle had gotten just out of shape enough that the caps did not readily slide on. Be careful you don't snap a tab or post off. Don't force it. Once you get it lined up right it should be fairly easy. Be aware that the number in the diagram on the website is incorrect. These really are ends for the handle itself, not something behind the handle, as the diagram indicated. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers