Kay H Jefferson , GA February 01, 2019 Hot surface indicator light lens cover was broken. Snapped the new piece in place. Who knew something so annoying could be fixed so easily? Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Anthony R Somers , NY February 08, 2016 Burner would go to a high setting and remain there even if dial control was set on 2 Installed a new infinite switch and problem solved. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers
Diane D Fort Mohave , AZ February 16, 2020 Appliance: Model WB25T10022 Missing 2 range lens Ordered the lenses from Appliance Parts Pros and when I received the parts, I just pushed and snapped them in. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Richard K Calabash , NC July 26, 2021 Lens had broken/terribly stained and warped oven racks I spent less than ten seconds snapping the part into place. It works perfectly and helps with the range's safety. The oven racks fit perfectly, making our oven look new again. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Krista G Tallahassee , FL April 07, 2020 Appliance: Model GE JD900C0K2CC Both red lenses covering the indicator lights on the range control panel were broken. Pulled the broken lenses out, cleaned some gunk off the areas where they snap in with rubbing alcohol and a cotton swab, and installed the new lenses. They are a bit of a force fit and you have to be careful not to break the side pieces that hold them in. It took a few moments to line each one up straight enough to snap in. I wish I thought to do this repair years ago! Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes