Robert L Cary , NC May 24, 2019 Appliance: General Electric Electric Dryer DPVH890EJ0MG Drum would not rotate intermittently. The Dryer is 10 years old GE Front Load DPVH890JEMG. The drum would intermittently not rotate at the beginning of a cycle and occasionally would rotate but then start and stop throughout the cycle. I did not check error codes, but the windings on the motor were black. So it seemed reasonable that the motor was overheating and sending a signal to the control board to stop. There is one screw under the knob and 9 screws on the front to get inside. I decided to replace the bearings, capacitor, belt and slides while I was in there because they were 10 years old and relatively cheap. Everything snapped in pretty easily and now it works. I was really hoping that it wasn't the control board and so far it seems that it wasn't. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers, Socket Set
Livingston H Westport , NY May 31, 2026 Appliance: General Electric Laundry Center GUD24ESSM0WW I didn’t have an error code because i didn’t enter into the diagnostic mode the capacitor was good there was a faulty connector I cut and stripped the wire and attached the new connector Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers