Theo S Tallahassee , FL October 01, 2014 Appliance: General Electric Refrigerator GSS25WGSBWW Ice maker would not dispense ice and chute/container would frost over When diagnosing the problem, I discovered that the ice door was not properly sealing and that the solenoid had appeared to rust/corrode forcing the door open. I replaced most of the ice dispenser internals (solenoid, crank, door, and spring) following the video. The door will now open when dispensing ice (which it does!), and will oddly stay open for a few seconds once I am finished, but does seal properly and the chute/container no longer frosts over. Read More... 76 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Richard W Philadelphia , PA October 02, 2018 Appliance: Model GSS25QGTB-WW Light bulb socket for water/icemaker defective on ge side by side 25 cubic feet Ordered new socket, watched your video of how to remove and access front electric panel. Removed connector wires, Removed rear unit (4 screws). Replaced bead socket and reassembled the unit and front panel. VERY easy, fast. Put in new bulb. Task complete. Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Randy J Virginia Beach , VA January 22, 2017 Appliance: General Electric Refrigerator TFX25CRBBWW Dispenser light would not work After replacing the bulb several times, I ordered and replaced the socket. Easy install and no more light bulbs blowing. The instruction video help immensely. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Kester Wade W Stanford , CA December 09, 2017 Appliance: General Electric Refrigerator DSS25KSRDSS Evaporator frosting issues. With the help and use of your detail videos, I was able to pinpoint the exact location of the necessary parts to check and change. It ended up being the main control circuit board that was defective and was changed. Fridge is working good again. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Nut Drivers, Pliers, Screwdrivers
William J Monongahela , PA April 20, 2018 Ice dispenser broke at the spring also the heat from the light being on all the time melted the housing shield Watched your video and ordered the parts I needed. Parts came it one day ahead of when promised. It was a pretty easy repair. All works great now! Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers