Ge WB13X32509 Spark Module OEM Part

Ordered the correct size drip bowls (All drip bowls have the same outside diameter but different (small, medium or large) inside hole diameters.) Removed 5 knobs by pulling straight up. Removed grate, burner cover, and burner from each of the five burners. Unscrewed two hold down screws from center of each drip bowl. Lifted each drip bowl, pulled wire off the igniter, pushed U-shaped clip off igniter and pulled igniter up thru top of drip bowl, pushed igniter down thru top of new bowl, pushed clip onto igniter. Before replacing the bowls and knobs, lift the glass top off the cooktop. Hold new spark module beside old module and pull off one wire at a time from the old module and press it onto the same terminal of the new module. Use a small socket to remove each screw holding down each end of the old module and screw in the new module. Replace the glass top, press each wire onto each igniter and place each bowl in its glass top hole. Press the glass top sideways to allow all the bowls to fall into place. Insert all the screws loosely into the bowls and slide the glass top again to center bowls. Tighten all screws and replace all knobs, burners, burner covers and grates.

Immediately unplugged the gas range, turned off the gas, removed the range and disassembled it. Obviously the harness that controls the gas was damaged so I did a Buick google search and found all of the parts I would need on here. Placed the order and fixed my range 2 days later.

Watch a video on appliancepartspros.com was able to install The harness switch and spark module. about 45 minutes.

Replaced module and igniters

Replaced the spark module.