Gibson Range / Cooktop / Oven Chassis Or Cabinet

The Oven Bottom Panel is an OEM component for Frigidaire oven models. Located on the base of the oven interior, this metal panel provides structure and support. 

Causes of a bad oven bottom panel include warping or damage due to exposure to high heat over time. Small nicks or cuts could allow heat to escape and reduce the oven's efficiency. Intentional or accidental impact during cleaning can also weaken the material.

Symptoms of a bad oven bottom panel include:

• Uneven or inefficient heat distribution within the oven
• Visible warping or damage to the panel surface
• Reduced heat retention leading to longer cook times
• Potential safety hazards if the metal is weakened

This OEM Frigidaire part is also compatible with some Kenmore models. 

This burner box is the structural pan beneath the cooktop that supports the surface burner components and shields internal parts from heat and spills. Replacing a damaged box restores proper burner alignment and a stable, secure cooking surface.

• Provides a rigid housing under the cooktop for burner heads, igniters, and related hardware
• Helps contain spills and protect wiring and insulation from heat exposure
• Keeps burners aligned so they sit level and openings match the main top
• Common failure signs: rust-through, cracks, or warping; stripped/broken mounting points; burners wobble or won't secure properly

• Disconnect power and shut off the gas supply before servicing.
• Remove the main top; document locations and transfer burners, igniters, grommets, and brackets to the new box.
• Handle sheet-metal edges carefully; wear cut-resistant gloves.
• After reassembly, restore gas and power, verify ignition, and leak-test any disturbed gas connections.

This replacement outer trim frame restores the door opening and cosmetic finish of your appliance, covering and securing edge components for a clean, factory look. It helps prevent gaps and protects inner components from damage. What it does

• Replaces a cracked, bent, or scratched outer frame to restore appearance and proper sealing
• Secures door edges and keeps internal trim and insulation aligned
• Helps reduce air leaks and keeps components protected from spills or impacts
• Fits the original mounting points for a direct-fit replacement when used with compatible models

• One outer trim frame

• Disconnect power to the appliance or unplug before starting any repair
• Use proper tools to remove door panels or trim; keep fasteners for reassembly
• Handle carefully to avoid scratching the new frame or nearby surfaces
• Follow the appliance manufacturer's service instructions for safe, correct installation

This replacement frame restores the outer door trim and helps keep the door aligned and sealed for proper operation. A straightforward, OEM-matching part for repairing damaged or bent door trim and improving fit. What it does:

• Provides structural support and alignment for the appliance door or door trim
• Helps maintain a proper seal to reduce drafts and improve cooling performance
• Stops rattling or vibration caused by a warped or damaged frame
• Restores original appearance where the outer trim is dented, cracked, or bent

• Designed to install in place of the original OEM frame; refer to your model-specific service manual for step-by-step instructions
• Disconnect power to the appliance before beginning any repair to avoid electrical shock
• Handle edges carefully to avoid cuts; use proper tools and fasteners as required
• Replace with OEM-specified fasteners for a secure fit