Huebsch Dryer Parts

This sensor monitors operating conditions and relays accurate feedback to the control so cycles run properly. Replacing a failed sensor helps restore correct operation and prevent erratic behavior or fault codes. What it does:

• Detects a specific operating condition and sends a signal to the control
• Helps the machine regulate cycle timing and performance
• Can cause error codes, cycles that won't start or advance, or intermittent shutdowns when failing
• Lead to inconsistent temperatures or sensing behavior depending on application

• 1 sensor

• Disconnect power (and shut off gas/water, if applicable) before servicing
• Access the sensor; note wire positions and connector orientation
• Install the new sensor in the same location and orientation; seat connectors fully
• Clear any stored faults and run a test cycle per the tech sheet

Sprocket that connects the motor to the drum drive system in your dryer. Replace if teeth are worn, stripped, or the part is cracked or broken.

This transformer kit supplies the control circuit with the required low-voltage control power, restoring reliable control operation and cycle control on compatible Speed Queen machines. Designed as a direct replacement for the original transformer assembly. What it does:

• Converts incoming 120V line power to the washer's control voltage so the control board and timers receive stable power
• Replaces a failed or noisy transformer that can cause intermittent control behavior or no power to control functions
• Helps resolve symptoms such as unresponsive controls, no display or cycle start, or erratic control operation
• Matches OEM fit and mounting points for a straightforward replacement when compatible

• Disconnect power to the appliance before starting work to avoid electrical shock
• Follow the manufacturer's service manual for wiring diagrams and correct connector locations
• Verify line voltage is 120V and confirm wiring connections before restoring power