Kenmore / Sears Cooktop Support Parts

Note: Quantity of two brackets

This rock plate support is used on many of the Jenn-air grill cartridge rock plates.

This element mounting spring secures a surface cooktop heating element to the range, keeping the element stable and ensuring consistent electrical contact for reliable heating. Replaces a worn or missing spring to restore proper element fit. What it does

• Holds the surface heating element in place under the cooktop or in the drip pan.
• Maintains stable mechanical and electrical contact so the element heats evenly.
• Prevents element wobble, movement, or poor seating that can cause intermittent heating.
• Commonly needed when an element drops, rattles, or fails to make solid contact.

• Disconnect power to the appliance before starting any repair.
• Remove the element and/or drip pan per the range service instructions to access the spring.
• Install the spring in the same orientation as the original; ensure the element seats fully and securely.

This oven element support holds the bake element securely in place so the heating element stays aligned for even cooking and safe operation. It's a simple replacement that restores proper element positioning. What it does:

• Holds the oven bake element at the correct height and alignment
• Prevents the element from sagging, shifting, or contacting the oven floor
• Helps eliminate arcing, rattling, or intermittent heating caused by a loose element
• Restores stable mounting after breakage, bending, or worn supports

• One element support

• Disconnect power to the appliance (unplug or shut off circuit breaker) before servicing
• Allow the oven to cool completely and remove the oven racks and bottom panel for access
• Most installations use existing screws/fasteners; replace only with manufacturer-specified hardware if missing

This plate is a flat mounting plate used to secure internal components and assemblies on compatible Frigidaire appliances. It provides a stable attachment point to keep parts aligned and reduce vibration for reliable operation. What it does:

• Serves as a mounting/support plate that fastens appliance components in place
• Helps keep moving parts aligned to prevent rattling or misalignment
• Restores secure attachment when a worn or damaged plate causes loose panels or parts
• Commonly used where a flat bracket or support is required inside the appliance

• Disconnect power (unplug appliance or shut off circuit breaker) before starting any repair
• Remove surrounding panels as needed to access the mounting location; keep hardware for reuse unless damaged
• Reuse original screws if in good condition; replace stripped or damaged fasteners