Kenmore / Sears Trash Compactor Parts

This bearing plate supports the dryer drum shaft and secures the bearing assembly so the drum spins smoothly and stays aligned. Replacing a worn plate restores stable drum rotation and helps reduce noise and rubbing. What it does:

• Provides a mounting surface and alignment for the drum bearing and shaft
• Keeps the drum centered to prevent wobbling, scraping, and uneven wear
• Reduces loud bearing or metal-on-metal noises caused by a damaged plate
• Helps maintain smooth drum rotation and proper belt alignment

• Turn power and gas off to the appliance before starting work
• Inspect surrounding components (bearing, shaft, seals, mounting screws) and replace if damaged
• Use correct fasteners and torque to secure the plate; improper mounting can cause noise or premature wear

Rotary switch knob for compactor control panel in biscuit color. Replace this control knob if cracked, broken, or missing to restore proper operation.

Replace your trash compactor's broken or missing handle. This exterior handle mounts to the front panel, allowing you to open and close the unit.

This is a stainless steel outer panel that attaches to the front of the trash compactor drawer. It provides the visible exterior finish and protects the inner drawer mechanism. Replace this panel if it is dented, scratched, corroded, or if you are updating the appearance of your trash compactor.

This latch pin secures the door latch mechanism on your trash compactor. Replace if the pin is broken, worn, or missing to restore proper door latching.

This power cord plate covers and secures the oven/range power cord where it enters the appliance, keeping the connection protected and helping prevent strain on the cord. It restores a finished look and helps keep wiring safely routed. What it does:

• Covers the terminal block area to protect power connections from dirt and accidental contact
• Helps keep the power cord routed and secured to reduce strain on the cord and terminals
• Can prevent air/dust intrusion behind the control cavity that could affect components
• Common replacement when the original plate is cracked, broken, or missing

• Always disconnect power at the breaker or unplug the appliance before starting work
• Typically attaches with two screws; keep screws and any gaskets from the old piece for reuse if undamaged
• Check the cord strain relief/terminal connections while replacing the plate; do not touch live terminals
• If wiring or the cord itself is damaged, replace or repair those parts per manufacturer instructions

Size: 6-20 x 1.0 inch.

Biscuit-colored front panel for trash compactor container. Replace this decorative trim piece if cracked, discolored, or damaged to restore appearance.

Button plug for trash compactor control panel. Replaces missing, cracked, or worn plugs that create gaps in the control surface. Restores appearance.