Ken C Greensboro , NC November 04, 2014 Broke gasket holder on both sides I ordered the parts and they arrived in 2 days. While the parts were in transit, I watched the video concerning replacing the gasket holder. WHAT A LIFE-SAVER! From start to finish took less than 60 minutes!!! Note: I did take some water and ran it down the channel where the gasket goes to make it easier to slide onto the gasket. Read More... 42 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Stephanie D Hinesburg , VT December 15, 2014 Broken pieces I watched a YouTube video and fix was easy. Only problem was the screws don't come with the gaskets. Read More... 19 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Rodney Z Demotte , IN August 07, 2015 Broken cam levers on both door gasket holders Ordered the correct parts here. Watched Youtube video on part replacement, which only covered replacing "complete" gasket holders, but was of great assistance with this repair. All I had to do is remove screw at bottom of old holder, slide out the metal hinge rod and transfer the locking clips, spring and rod to the new holders. Then installed the, now complete, holders to each door, per the video, and reinstall the old cam levers to them. Works perfectly, and took me about 15 -20 minutes. Read More... 10 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Don W Saint Clair , MI February 07, 2016 Appliance: LG Refrigerator LFC23760ST Gasket holder for refrdgerator and closing cams Replace. Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Eric H Wausau , WI November 08, 2014 No Took the oven door off, unscrewed the oven floor pan, unscrewed the burner tube then replaced the igniter. Fairly easy fix. 20-30 min Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers