Parts for Kenmore 21332: Maintop Parts

This mounting bracket secures and supports internal appliance components to keep assemblies aligned and stable. It restores proper fit and reduces vibration for smoother, quieter operation. What it does:

• Provides a secure mounting point for internal panels or assemblies
• Keeps components aligned to prevent rubbing, rattling, or wear
• Reduces vibration and movement during normal operation
• Helps maintain proper door/panel fit and function when used where specified

• Disconnect power (unplug appliance or shut off breaker) before starting any repair
• Basic hand tools are typically required; access may require removing exterior panels
• Handle edges carefully; wear gloves and eye protection to avoid injury
• Follow model-specific instructions for correct placement and fastener torque

This replacement wiring harness routes electrical power and signals between an appliance's control and its components, restoring proper connectivity and operation when the original harness is damaged or worn. What it does

• Connects control board to motors, switches, sensors and heating elements to enable normal appliance operation
• Replaces damaged, frayed or corroded wiring and connector ends that can cause intermittent power or component failures
• Helps prevent shorts and electrical arcing from exposed or burnt wires when installed correctly
• Matches OEM connector types and wire colors to simplify reconnection

• Disconnect power (unplug appliance or turn off breaker) before service to avoid shock or injury
• Handle connectors by the housings, not the wires; confirm connector seating and latch engagement
• Route and secure the harness following original clips and wire ties to avoid heat or pinch damage

These are replacement countertop mounting screws that secure the appliance to the countertop or cabinet, restoring a stable, flush fit and preventing movement or gaps. Sold as a 2-pack for quick, direct replacement. What it does

• Secures the appliance countertop or trim to the cabinet or counter to keep the unit from shifting.
• Helps eliminate rocking, gaps, or uneven alignment caused by missing or loose mounting screws.
• Restores proper fit and finish where original mounting hardware has been lost or damaged.
• Works with factory mounting points and standard driver heads for straightforward replacement.

• Two countertop mounting screws.

• Use the correct-size driver to avoid stripping the screw head.
• Tighten until snug; avoid over-tightening which can strip threads or damage the cabinet/countertop.
• Keep original brackets and hardware; replace only the missing or damaged screws as needed.

Size: 6-20 x 0.312 inch.