Mastercut Tiller Starter

This is a recoil starter assembly, first designed for rototillers, but also used on some models of wood chippers. It measures 7 inches in diameter and has a metal housing rather than plastic. This makes it more durable, suitable for heavy-duty lawn care responsibilities. The pull cord itself is standard nylon, well suited to pulling a heavier recoil. The purpose of a recoil starter assembly is to provide a relatively low-impact way of starting the engine. Instead of turning a crank, an operator can pull a cord, which is housed inside the starter assembly. Under ordinary circumstances, this assembly will rarely need to be entirely replaced, but damage can occur due to dropping or due to pulling the cord too hard when the engine is seized. In this case, a recoil starter assembly is a drop-in repair. Unscrew the old starter assembly, seat the new one, and screw it in. This is an OEM part sourced directly from the manufacturer, and it is sold individually.

This is a recoil starter assembly for lawn and garden power equipment. When the recoil starter rope is pulled, this causes the spark which starts the engine.A new recoil starter assembly will be needed if the recoil or pulley system has broken. The rope may become broken or frayed and the plastic on the pulley could crack. If the rope becomes loose and there is no tension when it is pulled, then a new recoil starter assembly will be needed.This part is a genuine MTD part and is an OEM part sourced directly from the manufacturer and it is sold individually. It is used on engines, lawnmowers, lawn tractors, and log splitters that are manufactured by MTD, Yard-Man, Yard Machines, Cub Cadet, Husky, and Troy-Bilt.

This recoil spring and pulley assembly is used in a variety of small gasoline engines that power devices such as mowers, lawn tractors, and log splitters, among other yard and landscaping devices. The assembly works by tightly coiling the spring in the starter housing. When the starter rope is pulled, the tension on the spring is suddenly released, creating a spark that fires the air/fuel mixture. The combustion starts the engine. The constant tightening and releasing of the tension at times will cause wear on the spring, resulting in the need to replace the spring and pulley assembly. To replace the recoil starter assembly, begin by removing the housing. Next, untie or starter rope and check to see if it is frayed and needs to be replaced as well. Remove the old assembly and install the new unit. Remember when re-tensioning the spring to wind the pulley in the opposite direction. Holding the pulley tightly so the spring does not release, attach the cap. Reattach the rope and coil it around the pulley. It is advisable to wear gloves for this task because the pulley and springs have sharp edges. This OEM certified replacement assembly is compatible with Yard-Man, Husky, Cub Cadet, MTD, Yard Machines, and Troy-Bilt yard equipment.