Bosch Range RGM8058UC Parts

The Regulator is an OEM part designed specifically for Bosch gas ranges and cooktops. It controls gas flow precisely according to the heat settings selected on the control panel. The regulator maintains safe, consistent gas pressure that enables full functionality across all burners. 

Causes of failure include mineral buildup restricting the gas valve opening over extended use. Physical damage from drops or accidental impact can also compromise regulation ability.

Symptoms include:

• Inability to achieve desired temperature levels across burners
• Gas pressure fluctuations between settings instead of consistency  
• Possible yellow flame issues or inefficient combustion
• Safety concerns requiring immediate replacement

Replacing with this genuine Bosch regulator restores optimized performance. It is also compatible with some Thermador, Gaggenau, and Dacor appliance models. Reliable pressure control supports enjoyable homemade meals with focused burner control from an OEM part.
 

This thermocouple is a temperature-sensing tube used in gas appliances to detect flame/temperature and help the appliance run safely and reliably. It restores accurate temperature feedback for proper operation. What it does:

• Senses temperature/flame presence and converts it to a voltage signal used by the gas control system
• Helps the appliance detect a flame failure condition and prevent unsafe operation
• Can resolve intermittent ignition or shutdowns when the thermocouple has failed
• Functions as the temperature feedback component in the burner assembly

• One thermocouple temperature-sensing tube

• Turn off gas and electrical power to the appliance before servicing
• Handle sensor tube carefully; avoid kinking or bending the sensing end
• Verify correct routing and secure connection to the gas control per OEM instructions

This thermocouple is a flame-sensing safety device for gas ranges and ovens that helps confirm the pilot or burner flame is present so the appliance can operate safely. It replaces a worn or faulty sensor to restore reliable flame detection. What it does:

• Detects the presence of a pilot or burner flame and signals the gas valve to stay open
• Commonly used in gas ovens and ranges as the flame safety sensor
• May be replaced if appliance won't light, flame won't stay lit, or oven/burner won't heat reliably
• Works as part of the gas safety system to help prevent unlit gas flow

• One thermocouple flame sensor

• Disconnect power and turn off the gas supply before starting any service
• Handle fittings carefully; do not kink or excessively bend the sensor probe
• Tighten gas connections to manufacturer torque specs and test for leaks after installation

A small mounting seating used to position and support related appliance components for correct alignment and operation. Replacing worn or damaged seating restores proper fit and helps reduce noise, vibration, or misalignment. What it does:

• Holds and centers mating parts to maintain proper alignment during use
• Helps stabilize panels or assemblies to reduce rattling and vibration
• Prevents uneven wear by keeping components seated correctly
• Can be a factor when parts skip, rub, or fit loosely

• Disconnect power and water (if applicable) before beginning any repair
• Typical install requires basic hand tools; handle carefully to avoid damage to surrounding parts
• Inspect adjacent fasteners, clips, and seals and replace if worn

Replacement spring for wall oven door or latch mechanisms. Needed when original spring is broken, stretched, or missing, affecting door closure or operation.

Gas burner won't light or clicks without igniting? This spark electrode assembly creates the ignition spark for reliable gas burner lighting. Moderate DIY.