Bosch Dryer WTW86560CH Parts

This replacement ring fits in its designated location within your appliance to secure or space components so they operate smoothly and stay aligned. Replacing a worn or missing ring helps restore proper fit and prevent looseness and noise. What it does:

• Positions or retains a mating part within the assembly
• Maintains correct alignment/clearance between components
• Helps reduce vibration and wear from parts rubbing
• Common clues of a bad or missing ring: loose/wobbly component, rattling, misalignment, or visible damage

• 1 ring

• Disconnect power and shut off water or gas, if applicable, before servicing
• Refer to your model's service manual for access steps and orientation
• Note the ring's position before removal; seat the new ring fully and evenly
• Inspect related parts for wear and replace if damaged

Supports smooth drum rotation in your dryer. Replace if you hear squeaking, whistling, or rumbling during cycles. Verify fit with your model number.

Temperature monitoring sensor located in the dryer's heating system that regulates drying temperatures. Replace if clothes aren't drying properly, take too long to dry, or if the dryer overheats.

Replacement leveling foot for dryers. Installs on the bottom corner to elevate and stabilize the appliance. Order if cracked, broken, or missing.

Drive belt transfers power from motor to drum in your dryer. Replace if you hear squealing, slipping, or drum won't turn. Verify fit with model number.

This is a drum support roller that sits on an axle and helps the dryer drum rotate smoothly during operation. The roller bears the weight of the drum and its contents, reducing friction and noise. Replace this part if you hear thumping, squealing, or rumbling noises while the dryer is running, or if the drum no longer spins freely.

Supports and seals your dryer door for proper alignment. Replace if door leaks air, won't close securely, or makes excessive noise. Verify fit with model.

If your dryer door won't stay closed or the handle broke, this metal hook works with the door latch for secure closure. Quick 5-minute repair for Bosch dryers.

Seals the gap between your dryer door and drum to contain heat and prevent lint escape. Replace if torn, cracked, or causing longer dry times.

Dryer won't start or door won't stay closed? This door latch assembly secures the door during operation, allowing cycles to run. Moderate DIY repair.

Dryer drum baffle lifts and tumbles clothes while circulating air evenly. Replace if cracked, loose, or causing noise. Verify fit with your model number.

Tension roller for dryers. Mounts to the support bracket to maintain proper belt tension around the drum. Replace if worn, squeaking, or damaged.

This is a replacement seal used to restore a watertight connection and help prevent leaks in compatible appliances. It provides a simple, low-cost way to replace a worn or damaged sealing element. What it does:

• Creates a secure, leak-resistant barrier at the mating surfaces where installed
• Helps stop visible leaks and drip symptoms associated with damaged seals
• Restores intended sealing performance when original gasket or seal is deteriorated

• Inspect mating surfaces for damage or debris and clean before installing the new seal
• Make sure the seal seats evenly and is fully inserted into its groove or recess
• Replace only with the correct OEM part number for a proper fit
• Disconnect power and water supply and follow appliance safety procedures before servicing

Access panel cover that shields internal components from dust and moisture. Replaces cracked, broken, or missing exterior panels to restore finish.

Replacement drum taper cone for your dryer. This structural component secures the drum assembly. Order a new taper if yours is cracked or damaged.