Gaggenau Range EB388110 Parts

This Halogen Bulb is an OEM part for Bosch Ranges. It provides illumination for the range's interior. Continuous use or high temperatures can cause the bulb to burn out or fail.

What Causes a Bad Halogen Bulb: 
Repeated heating and cooling cycles, along with continuous use, can cause the halogen bulb to burn out or break.

Symptoms of a Bad Halogen Bulb:

• The bulb is not lighting up
• Visible signs of damage or a broken filament
• Flickering or intermittent lighting

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This is a flexible sealing strip that fits along the oven door to create an airtight seal when the door is closed. It prevents heat from escaping during cooking and helps the oven maintain consistent temperatures. Replace this strip if you notice heat leaking around the door, uneven cooking, or if the seal appears cracked, hardened, or deformed.

Oven not heating evenly or taking too long to preheat? The bottom heating element provides main baking heat. Moderate DIY repair in 30-45 minutes.

This electronic control module manages a dishwasher's user interface and wash cycle logic so the appliance responds correctly to commands and runs programmed cycles. Replaces a failed control board to restore normal cycle selection and operation. What it does:

• Interprets button/knob inputs and starts the selected wash cycle
• Sends signals to pumps, valves, and heaters to control cycle timing
• Stores and runs cycle logic and diagnostics used by the machine
• Common symptoms: unresponsive or blank display, touchpad/buttons not working, cycles won't start, or dishwasher stops mid-cycle

• Disconnect power to the appliance before attempting any service
• Handle the board by its edges and avoid touching components to prevent ESD damage
• Reconnect all wiring harnesses to their matching connectors; ensure secure seating

This door hinge provides the pivot point that lets the appliance door open smoothly and close flush. Replacing a worn or bent hinge restores proper alignment and sealing for safe, reliable door operation.

• Provides the pivot point that guides door opening and closing
• Helps keep the door square to the cabinet for a consistent seal
• Wear or damage can cause sagging, binding, gaps, or a door that won't close flush
• Restores smooth movement and proper door alignment

• Disconnect power before servicing; also shut off gas or water
• Support the door during removal to prevent damage or injury
• Transfer any mounting screws/brackets from the old hinge to the new one
• After installation, verify door alignment and gasket contact; adjust as needed

This is a sealing gasket designed to create an airtight fit on an oven or range component such as a door or lamp glass assembly. It prevents heat from escaping and protects internal parts from moisture and debris. Replace this seal if you notice heat leaking from the oven, uneven cooking temperatures, or visible wear and cracking on the existing gasket.

This oven temperature probe is the internal sensor that monitors cooking cavity temperature so the oven control can regulate heat for accurate cooking and bake results. It's a direct-replacement sensing probe for compatible Bosch ovens. What it does:

• Measures internal oven temperature and sends readings to the control board
• Allows the oven to maintain set temperatures for consistent cooking
• Common symptoms of a failing probe: inaccurate oven temps, oven not reaching set temperature, or temperature-related error codes
• Works with the oven's control system to help cycle heating elements or gas valve

• Disconnect power to the appliance before servicing to avoid shock hazard
• Handle the probe and its wiring gently; avoid sharp bends or pulling on connectors
• Verify connector orientation and secure connections to the control board per OEM diagram

This is a glass panel that serves as part of the control panel area on a range or oven, covering and protecting the controls while allowing visibility of indicators and displays. It provides a smooth, finished surface on the front of the appliance. Replace this panel if it is cracked, chipped, shattered, or if the surface has become cloudy or damaged from heat exposure.