Gaggenau Freezer RF411701 Parts

Removes impurities from your refrigerator's water and ice supply. Replace every 6 months for clean, fresh-tasting water. Verify fit by model number.

This slide rail retainer secures the freezer drawer or shelf rails in their proper position within your freezer compartment. It prevents the rails from shifting or coming loose during normal use of the drawer system. Replace this part if your freezer drawer doesn't slide smoothly, falls off its track, or if the rails have become loose or misaligned.

Secures freezer baskets to drawer rails in your refrigerator. Replace if clip is cracked, broken, or missing to keep bins properly mounted and stable.

This sensor monitors operating conditions inside the appliance and reports to the control so cycles run correctly and safely. When the sensor fails, the control may receive inaccurate feedback, leading to irregular performance. What it does:

• Detects key conditions inside the appliance and sends a signal to the control
• Helps the control regulate heat and cycle progress
• Failure symptoms can include erratic cycle times, poor heating performance, or sensor-related error messages
• Can prevent the appliance from starting or completing a cycle if readings are out of range

• 1 sensor

• Disconnect power before servicing; shut off water supply if applicable
• Access the sensor and note wire orientation before removal
• Ensure any sealing surface is clean and the sensor is seated properly; check for leaks after reassembly where applicable
• Run a diagnostic or test cycle after installation to clear errors and verify operation

Secures the water filter in your refrigerator for a snug, leak-free fit. Replace if lost during filter changes, cracked, damaged, or worn out over time.

This is a replacement micro switch used in select Bosch-built appliances. It opens and closes an electrical circuit when actuated by a lever or cam, enabling functions like starting/stopping a cycle or detecting a position.

• Controls power or signals by opening/closing a low-voltage circuit when pressed
• Commonly used for on/off, door/lid, or position-sensing functions
• Failure may cause the unit not to start, intermittent operation, or features that won't engage
• May also present as unresponsive buttons or functions that only work when pressed a certain way

• Disconnect power before servicing; verify no voltage is present
• Access location varies by model; remove panels as needed to reach the switch
• Note wire positions and terminal orientation before removal
• Test continuity with a meter after installation to ensure proper operation

Leveling foot installs at the refrigerator base to support and level the unit. Replace if worn, cracked, broken, or missing to restore stability.

Fixes ice maker overflow and water leaking into freezer. This water inlet valve controls water flow to your dispenser and ice maker. DIY repair.

Mounting hardware kit secures refrigerator components in place. Replaces worn, missing, or damaged fasteners that cause rattling or loose parts inside unit.

Refrigerator not cooling or compressor not starting? This start relay controls the signal that initiates the compressor. Direct replacement part.

Freezer not cooling or running too warm? This fan motor circulates air across coils to restore proper temperature control. Fixes poor cooling issues.

This hinge pin secures the door hinge mechanism and allows your refrigerator or freezer door to pivot smoothly. It maintains proper door alignment and prevents the door from sagging or binding. Replace this part if your door won't close properly, sags when opened, or if you hear squeaking or grinding when opening the door.

Trim strip that provides a finished edge and protective cover at its mounting location. Replace when cracked, worn, or missing to restore proper appearance.

Vertical trim strip that covers the gap between refrigerator doors. Replace if cracked, chipped, discolored, or missing to restore a clean appearance.

Restores proper door alignment and smooth operation. Replace if your refrigerator door sags, drags, or has uneven gaps. Verify fit with your model number.

If your refrigerator cabinet feels warm or cooling is weak, the condenser fan may have failed. This fan circulates air over the condenser coil to remove heat.