Gaggenau Range VF230110 Parts

M4 rubber gasket creates watertight seal and reduces vibration around fasteners. Replace when worn, cracked, or leaking. Verify fit with your model number.

This is a sealing component designed to fit around the gas valve area of a range or oven. It prevents gas and heat from escaping at the valve connection point, ensuring a safe and proper seal. Replace this seal if you notice gas odors near the valve, signs of heat damage around the connection, or if the old seal has become brittle or cracked.

A small support bracket that secures the mounting strip and helps hold appliance panels and components in proper alignment for reliable operation. Replaces a worn or damaged bracket to reduce rattling and improve fit. What it does

• Supports and secures the mounting strip that attaches panels or trim to the appliance
• Keeps panels, trim, or adjacent components aligned and stable
• Helps prevent movement, vibration noise, or gaps caused by a loose or broken bracket
• Commonly replaced when the bracket is cracked, bent, or missing

• One mounting strip bracket

• Disconnect power (and water, if applicable) before servicing the appliance
• Use appropriate hand tools; mounting screws or clips may be required
• Handle panels and sharp sheet metal carefully to avoid cuts or damage
• Follow the OEM service manual or instructions for exact removal and reassembly steps

This thermocouple is a flame-sensing probe used on gas burners to detect pilot/standing flames and allow the valve to stay open. It replaces a worn or failed sensor to help restore reliable ignition confirmation. What it does:

• Detects pilot or burner flame presence and signals the gas valve to stay open
• Commonly fails when the burner won't stay lit or the pilot won't register
• Helps prevent gas valves from remaining open if the pilot flame is absent
• Matches OEM fit and connection style for direct replacement

• Turn off gas supply and electrical power before servicing
• Handle probe tip and wiring carefully; avoid bending or kinking the sensor
• Verify proper mounting position and secure connection to the gas valve