Gaggenau Range VG231321SG Parts

This thermocouple monitors the burner flame and works with the safety valve. It allows gas flow only while a flame is present and lets the valve close when no flame is detected, helping restore dependable burner operation.

• Senses burner flame heat and sends a small millivolt signal to the safety valve
• Works with the flame-failure safety system to maintain or cut gas flow based on flame presence
• Common symptoms can include: burner lights but goes out when the knob is released; needing to hold the knob down unusually long to keep the burner lit

• Disconnect power and shut off gas before servicing
• Allow the unit to cool; remove grates/caps to access the sensor tip and route the lead to the valve connection as originally installed
• Do not kink or sharply bend the lead; position the tip within the burner's flame envelope
• After reassembly, restore gas/power and test burner operation

M4 rubber gasket creates watertight seal and reduces vibration around fasteners. Replace when worn, cracked, or leaking. Verify fit with your model number.

A small support bracket that secures the mounting strip and helps hold appliance panels and components in proper alignment for reliable operation. Replaces a worn or damaged bracket to reduce rattling and improve fit. What it does

• Supports and secures the mounting strip that attaches panels or trim to the appliance
• Keeps panels, trim, or adjacent components aligned and stable
• Helps prevent movement, vibration noise, or gaps caused by a loose or broken bracket
• Commonly replaced when the bracket is cracked, bent, or missing

• One mounting strip bracket

• Disconnect power (and water, if applicable) before servicing the appliance
• Use appropriate hand tools; mounting screws or clips may be required
• Handle panels and sharp sheet metal carefully to avoid cuts or damage
• Follow the OEM service manual or instructions for exact removal and reassembly steps

Fix loose or burnt electrical connections with this terminal connector. Essential for restoring power flow in appliances. Simple repair requiring basic tools.

Covers the cooktop burner to protect internal parts and restore a finished appearance. Replaces a cracked, chipped, or missing lid for proper fit.

This is a replacement nut for the VG 230 assembly, used to secure the associated hardware on compatible Bosch appliances. Installing the correct nut restores safe fastening and helps stop looseness, rattles, or misalignment. What it does:

• Secures the VG 230 component or bracket to its mounting point
• Keeps threaded connections tight under vibration and normal use
• Helps prevent intermittent contact, rattling, or movement of the assembly
• Restores proper mechanical alignment after a stripped or missing fastener

• Disconnect power and water (if applicable) before servicing the appliance.
• Use the correct size wrench or socket to avoid rounding the nut.
• Replace with the exact OEM part to maintain fit and function; do not overtighten.

This rubber door seal forms a watertight barrier around the dishwasher door to help prevent leaks and keep water contained during cycles. Replaces worn or damaged seals to restore proper sealing and reduce drip and pooling near the door. What it does:

• Creates a continuous water seal around the dishwasher door to prevent leaks during wash cycles
• Keeps water and spray inside the tub for efficient cleaning
• Helps reduce moisture and residue buildup at the door edge
• Commonly replaced when you see visible cracks, flattening, or leaking at the door

• One replacement door sealing gasket

• Simple gasket replacement; remove the old seal from the door channel and press the new seal into place, working around the full perimeter
• Make sure the seal sits fully into the door channel and the ends align without gaps
• Disconnect power and water supply before starting work and follow manufacturer instructions