Kenmore Range Hood 233.5888390 (2335888390, 233 5888390) Parts

Carbon filter for range hoods and over-the-range microwaves. Dimensions: 4-7/8" x 27" x 3/8" (4.875 x 27 x 0.375). Rectangle shape. Removes cooking odors from cooking air. Replace when clogged, discolored, or every 6-12 months.

Replace your range hood's damper flap if cracked, broken, or missing. This flap installs in the ductwork to control airflow and prevent backdrafts.

A replacement damper that helps control airflow through the hood or exhaust duct, preventing backdrafts and improving ventilation performance. Simple swap of a worn or stuck flap restores proper vent operation and airflow control. What it does:

• Seals the exhaust opening to block outside air and prevent backflow when the fan is off
• Opens freely with exhaust fan operation to allow proper ventilation
• Commonly replaces units that are stuck, bent, noisy, or no longer closing fully
• Helps reduce drafts and unwanted odors entering the home through the duct

• One damper

• Turn off power to the appliance before accessing the damper to avoid injury
• Access may require removing the hood cover or grille—use basic hand tools
• Inspect mounting screws, gaskets, and surrounding ductwork and replace any damaged hardware

This is a replacement component for select Broan appliances. Use it to replace a missing or damaged factory piece so the unit can be returned to normal service. Purchase only when the part number matches your parts list. What it does:

• Replaces a specific factory component to restore original fit or function
• Addresses symptoms like a missing piece, visible damage, or improper fit
• Helps stop rattling or loose assemblies when the correct part is installed
• Serves as a direct physical replacement when matched to the OEM part number

• Always disconnect power at the breaker or unplug the appliance before servicing.
• Compare the item to the original part and your parts diagram to fit before installation.
• Use basic hand tools; avoid forcing components—if mounting hardware is required, install as shown in the OEM diagram.

This is a direct replacement part sold under the manufacturer's part number for use with compatible ventilation and range hood products. It provides a like-for-like swap when the original component fails, restoring normal function. What it does

• Replaces a failed or damaged factory part to restore appliance operation.
• Prevents intermittent or complete loss of the related feature when installed correctly.
• Helps avoid makeshift repairs that can cause further damage or unsafe operation.
• Works only in models specified by the manufacturer for this part number.

• One replacement part as shown and labeled by the manufacturer.

• Disconnect power to the appliance before attempting any repair to avoid shock or injury.
• Use proper tools and secure fasteners to the manufacturer's specifications; do not force parts into place.

This wire harness routes power and signals between the hood's motor, lights, switches and controls to restore electrical connectivity and proper operation. It replaces a damaged or burnt wiring assembly to help clear electrical faults. What it does:

• Connects the blower motor, light sockets, and control switches to the hood's power supply
• Restores broken or corroded wiring paths that can cause intermittent operation or complete failure
• Helps stop arcing, shorts, or blown fuses when the original harness is damaged
• Enables proper function of speed switches and lighting circuits once installed

• One complete wire harness assembly as shown

• Disconnect power to the appliance at the breaker before starting any work
• Verify connector orientations and secure all wiring with the original clips or mounts
• Inspect adjacent components for heat or damage that could have affected the harness