Kenmore Dehumidifier 253.50300002 (25350300002, 253 50300002) Parts

Replacement hose cap for your dehumidifier's drain hose connection. Needed when the original cap is cracked, broken, lost, or no longer seals properly.

Reduced airflow or no air circulation from your dehumidifier? A damaged blower wheel is often the cause. This part restores proper air movement.

Dehumidifier not collecting water or shutting off when full? This bucket assembly with float and pin restores automatic shutoff. Moderate difficulty repair.

Dehumidifier won't start or stops running? A faulty compressor overload protector causes sudden shutdowns. Direct replacement part, moderate difficulty.

Motor making noise or loose? This motor mounting nut secures motors in refrigerators, ranges, and other appliances. Simple install takes 15 minutes.

Fix a dehumidifier that won't start or runs briefly then stops. This compressor starter relay restores reliable starting. Moderate DIY repair.

Secures the blower wheel assembly in air conditioners and dehumidifiers. Replace if worn, cracked, or causing vibration noise. Verify fit with model number.

This wiring diagram is the factory schematic sheet that shows the appliance's wiring layout and circuit connections, helping you read the electrical schematic and wiring during service or parts replacement. What it does:

• Provides the factory electrical schematic for identifying circuits, wire colors, and connector locations
• Helps technicians and DIYers trace wiring for diagnostics and safe troubleshooting
• Replaces a torn, faded, or missing diagram so wiring information remains available on the appliance
• Reduces risk of miswiring by showing original manufacturer connections and component references

• Always disconnect power to the appliance before inspecting or replacing the wiring diagram
• Affix the replacement diagram in the same visible location as the original for future service reference
• Handle the sheet carefully to avoid tearing; use original mounting holes or adhesive as applicable