Kenmore Air Conditioner 253.67090 (25367090, 253 67090) Parts

This rubber compressor mounting grommet cushions and isolates the compressor to reduce vibration and noise that can transfer to the cabinet. It helps maintain stable compressor positioning for quieter, smoother operation. What it does:

• Absorbs compressor vibration to lower noise and rattling
• Dampens movement that can cause abrasion or wear on mounting hardware
• Helps maintain proper alignment of the compressor assembly
• Common symptom: excessive buzzing, vibration, or rattling from the back of the appliance

• Always disconnect power to the appliance before servicing.
• Support the compressor before removing mounts to prevent shifting or damage.
• Inspect surrounding mounts and hardware; replace any worn or damaged pieces.

This replacement control panel window is the clear front lens that covers and protects an air conditioner's control/display area while keeping buttons and indicators visible. It restores a clean, readable appearance and protects internal controls. What it does:

• Replaces a cracked, scratched, fogged or missing control panel lens so displays and buttons are visible
• Shields internal controls and electronics from dust, moisture splashes, and everyday wear
• Maintains original fit and appearance for the unit's control area
• Helps preserve resale value and user usability by restoring a finished front surface

• One control panel window (1 piece)

• Disconnect power to the unit before starting any work
• Usually installs from the front; may require removing outer trim or bezel and a few screws or clips
• Handle the lens carefully to avoid scratches; use soft gloves and a non-abrasive surface during installation
• Inspect seals and replace if compromised to maintain weather protection

This rubber grommet cushions and secures appliance panels or components to reduce vibration and wear. It helps restore stable mounting and quiet operation when a worn grommet causes movement or noise. What it does:

• Cushions and isolates panels or components to reduce vibration-related noise
• Holds wires, hoses or panels in place at a mounting hole or pass-through
• Prevents metal-to-metal contact and protects openings from abrasion
• Commonly used when you notice rattling, loose panels or chafed wiring at an access hole

• Disconnect power (and water if applicable) before servicing the appliance
• Remove the outer panel or access cover to reach the grommet mounting location
• Press the grommet into the mounting hole until fully seated; trim or replace adjacent fasteners as needed
• Replace any damaged clips or retainers and test appliance operation after reassembly

Galvanized Steel