Kenmore Room Air Conditioner 253.70128111 (25370128111, 253 70128111) Parts

This handheld remote control sends wireless commands to your appliance so you can change settings from a distance. It replaces a lost or non-working remote to restore convenient, button-based control of functions and modes. What it does:

• Sends infrared/wireless signals to the appliance receiver to change settings
• Lets you adjust common functions such as power, mode and temperature/fan settings
• Restores remote operation when the original remote is lost, damaged or unresponsive
• Resolve issues where the appliance doesn't respond to remote commands

• Install fresh batteries before first use and after long storage; use correct battery type
• Point remote at the appliance receiver and test from several feet away; remove obstructions
• If the appliance doesn't respond, check receiver/IR sensor and power to the appliance
• Handle electronic parts carefully; disconnect power to the appliance before servicing internal components

This thermistor is the refrigerator temperature sensor that helps the control board monitor and regulate cooling. Replacing a failed thermistor restores accurate temperature readings for more consistent fridge and freezer performance. What it does:

• Senses internal air temperature and sends that information to the control board
• Helps the defrost and compressor cycles run at the correct times
• Commonly linked to symptoms like inconsistent temperatures, error codes, or a unit that runs constantly
• Does not control cooling directly but provides the temperature feedback the system needs

• Always disconnect power to the appliance before beginning service
• Typically located in the fresh food or freezer compartment near the evaporator
• Handle the sensor and wiring gently; avoid pulling on the wires or bending the probe sharply
• If troubleshooting, verify wiring and sensor resistance per the manufacturer's service instructions before replacement

This replacement evaporator fan blade circulates cold air across the freezer and refrigerator compartments to help maintain even temperatures and efficient cooling. Designed to match the OEM shape for proper airflow and fit. What it does:

• Spins on the evaporator fan motor to move cold air through the evaporator and into the cabinet
• Helps stabilize internal temperatures and reduce frost buildup when operating correctly
• Commonly replaced when cracked, chipped, warped, or causing unusual noise or poor airflow
• Restores proper airflow to improve cooling performance when the original blade is damaged

• One fan blade

• Disconnect power before servicing the appliance to avoid electrical shock or injury
• Inspect the motor shaft and mounting for damage; clean debris before installing the new blade
• Ensure the blade is seated fully and rotates freely without rubbing against the housing
• If the motor shows excessive wear or noise, replace the motor assembly as needed rather than just the blade