Kenmore Air Conditioner 580.72189200 (58072189200, 580 72189200) Parts

Replacement drain pipe that routes wastewater from the appliance pump to the home drain. Restores proper drainage and helps prevent leaks or standing water when the original tubing is cracked, clogged, or damaged. What it does

• Directs wastewater from the pump to the household drain so the appliance can complete normal drain cycles.
• Replaces cracked, split, kinked, clogged, or leaking tubing that can cause slow draining or standing water.
• Fits the OEM drain outlet and drain connection; secures in place with hose clamps to maintain a watertight seal.
• Matches OEM shape and routing to avoid pinches or improper drainage.

• Always unplug the appliance and turn off the water supply before beginning service.
• Remove the access panel to reach the pump/drain connections; detach the old pipe and install the replacement in the same orientation.
• Use the original hose clamps or replace with equivalent clamps; tighten until snug—avoid overtightening.
• After installation, run a short drain cycle and check all connections for leaks.

This NTC thermistor assembly senses temperature and sends readings to the control board so the appliance maintains the correct cooling cycle. It replaces a failed or intermittent temperature sensor to restore proper temperature regulation. What it does:

• Measures compartment temperature and relays the signal to the control board
• Helps the appliance decide when to run compressor and fans for stable cooling
• Commonly replaces units that cause incorrect temperature readouts, excessive frost, or compressor cycling
• Works as the OEM temperature-sensing element in the appliance's refrigeration system

• Disconnect power before accessing internal components to avoid shock
• Handle sensor and wiring gently; avoid bending or crimping the thermistor tip
• Verify connector seating and routing to prevent pinched wires or interference with moving parts

This clamp secures a line or connection inside your appliance, maintaining a tight fit under vibration. Replacing a fatigued clamp helps prevent leaks or disconnections and keeps components anchored so the system operates reliably.

• Holds a line/fitting firmly to keep the joint sealed and secure
• Helps prevent leaks or disconnections at hose/tube connections
• Resists vibration that can loosen fittings during operation
• Replace if bent, weakened, or corroded, or if the connection repeatedly loosens

• Disconnect power and, if applicable, shut off water supply before service
• Note clamp orientation and routing; seat the clamp just behind the fitting bead/stop
• Use the correct tool for your clamp style to compress or tighten evenly
• After reassembly, restore utilities and test for leaks or movement