Kenmore Air Conditioner 580.78183890 (58078183890, 580 78183890) Parts

Replacement thermostat assembly that regulates temperature and cycling to help keep food at the intended temperature. Restores proper temperature sensing and on/off control for refrigerators or freezers when the original unit fails. What it does:

• Detects internal temperature and signals the compressor/fans to cycle on and off
• Restores stable temperatures when a failed thermostat causes overcooling or warming
• Common symptom fixes: appliance runs constantly, won't reach set temperature, or cycles erratically
• Works as the temperature-control component in the cooling circuit

• Disconnect power to the appliance before starting any repairs
• Handle the sensing element/sensor carefully and avoid pulling on wires or connectors
• Reconnect all electrical connectors securely and route any harnesses the same way as the original

Replacement drain pipe that routes wastewater from the appliance pump to the home drain. Restores proper drainage and helps prevent leaks or standing water when the original tubing is cracked, clogged, or damaged. What it does

• Directs wastewater from the pump to the household drain so the appliance can complete normal drain cycles.
• Replaces cracked, split, kinked, clogged, or leaking tubing that can cause slow draining or standing water.
• Fits the OEM drain outlet and drain connection; secures in place with hose clamps to maintain a watertight seal.
• Matches OEM shape and routing to avoid pinches or improper drainage.

• Always unplug the appliance and turn off the water supply before beginning service.
• Remove the access panel to reach the pump/drain connections; detach the old pipe and install the replacement in the same orientation.
• Use the original hose clamps or replace with equivalent clamps; tighten until snug—avoid overtightening.
• After installation, run a short drain cycle and check all connections for leaks.

This clamp secures a line or connection inside your appliance, maintaining a tight fit under vibration. Replacing a fatigued clamp helps prevent leaks or disconnections and keeps components anchored so the system operates reliably.

• Holds a line/fitting firmly to keep the joint sealed and secure
• Helps prevent leaks or disconnections at hose/tube connections
• Resists vibration that can loosen fittings during operation
• Replace if bent, weakened, or corroded, or if the connection repeatedly loosens

• Disconnect power and, if applicable, shut off water supply before service
• Note clamp orientation and routing; seat the clamp just behind the fitting bead/stop
• Use the correct tool for your clamp style to compress or tighten evenly
• After reassembly, restore utilities and test for leaks or movement