Kenmore Range 647.6037260 (6476037260, 647 6037260) Parts

The Igniter Mounting Screw is an OEM replacement part for GE ovens and ranges. This screw secures the igniter to the burner assembly, ensuring it remains firmly in place for consistent and reliable ignition. Its precise fit and durable design help maintain the stability and functionality of the igniter.

Over time, mounting screws can become corroded, stripped, or lost during repairs or maintenance. A missing or damaged screw may result in a loose igniter, affecting the appliance's ability to ignite properly.

Symptoms of a bad or missing igniter mounting screw include:

• The igniter becoming loose or misaligned

• Difficulty securing the igniter during installation or repair
• The burner fails to ignite reliably or consistently
• Increased noise or movement of the igniter during operation

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This replacement screw secures appliance components so panels, brackets, and assemblies stay tight and aligned. Replace stripped or missing hardware to eliminate rattles and keep your unit assembled safely and correctly.

• Fastens panels, brackets, or components to the appliance frame
• Restores a secure fit when the original screw is lost, stripped, or corroded
• Helps prevent vibration noise and movement during operation
• Supports proper alignment of trim and assemblies

• Disconnect power; for gas units, also shut off the gas supply
• Use the correct driver to avoid stripping the head; do not overtighten
• Inspect and address damaged mating threads, clips, or brackets before reinstalling
• Refer to your model's parts diagram to confirm location and quantity

Includes 12 washers.

Replacement fastener used to secure appliance components. If a screw is missing or damaged, panels and brackets can loosen or rattle. Installing a new screw restores a tight fit and helps keep parts properly aligned.

• Fastens panels, brackets, or internal components as designed for the model
• Replaces missing, stripped, or corroded hardware
• Helps reduce vibration/rattling and restores proper fit
• Maintains alignment and a secure assembly after service

• Disconnect power; shut off gas if applicable before servicing
• Support components while removing/installing fasteners
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Replace all required screws in a location for even clamping and proper fit

Nickel

This Loxit locking retaining nut secures components and terminals on home appliances to keep parts fastened and reduce vibration-related loosening. It's a small but essential hardware piece for reliable mechanical and electrical connections. What it does:

• Secures terminals, studs, or posts to prevent movement and maintain electrical contact
• Holds small assemblies or panels in place to stop rattling or loosening from vibration
• Restores proper fit where a worn or missing nut causes a loose knob, control, or connection
• Helps prevent intermittent electrical contact caused by loose fasteners

• One Loxit locking retaining nut

• Disconnect power to the appliance before starting any repair.
• Verify nut thread and size match the stud before installation; use correct hand tools.
• Tighten securely but avoid over-torquing to prevent stripping or damage.
• Ensure proper seating and inspect wiring for wear.

This round plug button is a small replacement trim plug that snaps into place to cover unused holes or fastener openings, keeping the appliance finish neat and protecting internal components from dust and debris. What it does

• Covers and protects unused openings or mounting holes in appliance panels
• Keeps dirt, moisture and small debris out of internal cavities
• Restores a clean, finished appearance to damaged or missing trim plugs
• Commonly used where a low-profile, snap-in plug is needed

• One round plug button

• Disconnect power to the appliance before servicing when applicable
• Press the plug squarely into the opening until it snaps into place; some models may require gentle pry to remove
• Use a non-marring tool for removal to avoid scratching surrounding surfaces