Lg Refrigerator LSCI307ST Parts

This is a truss-head tapping screw used to secure trim, panels, and small assemblies on compatible LG appliances. It provides a low-profile, wide-bearing head that helps hold parts flush and resist pull-through. What it does:

• Fastens plastic and sheet-metal components where a self-tapping thread is needed
• Truss head spreads load to prevent damage to soft or thin materials
• Helps secure control panels, brackets, or trim pieces that require a low-profile head
• Common replacement when original mounting screws are missing, stripped, or corroded

• One truss-head tapping screw

• Use the correct screwdriver bit and moderate torque to avoid stripping the screw or workpiece
• Start threading straight and let the screw form threads without forcing at an angle
• Disconnect power and follow appliance-specific service safety procedures before working internally
• Replace any damaged mating threads or clips for a secure fit

Replacement screw that secures panels, trim pieces, and mounting brackets on cooktops and ranges. Needed when screws are missing, stripped, or damaged.

Secures interior panels and components. Replace when stripped, corroded, or missing to stop rattles and secure loose trim. Verify fit with your model number.

Replacement mounting screw for microwave panels and components. Secures brackets, vents, and assemblies. Needed when original fastener is missing or damaged.

This 4.0x16mm tapping screw secures trim, panels, and brackets on ranges and microwaves. Replace missing, stripped, or damaged screws during repair.

This is a circular wire harness holder that secures and organizes internal wiring within the range. It clips onto the frame or mounting points to keep wires routed properly and away from heat sources. Replace this part if it is broken or missing, which can cause loose wiring or potential contact with hot surfaces.

This idle bracket supports the dryer/tumble assembly's idler pulley so the drive belt stays aligned and tensioned for reliable drum rotation. Replaces a worn or broken bracket to reduce belt slippage and related noise. What it does:

• Secures the idler pulley in the correct position for proper belt tension and tracking
• Prevents belt rubbing, slipping, or premature wear that can cause noisy operation
• Restores stable drum rotation when a cracked or damaged bracket is the cause of belt issues
• Helps maintain correct alignment of the drive belt and pulley system

• Disconnect power (unplug or turn off breaker) before beginning any repair
• Support the drum and/or belt while removing and reinstalling the bracket to avoid misalignment
• Use common hand tools; retain original fasteners unless replacements are specified
• After installation, test the dryer through a short cycle to ensure smooth, quiet operation

Mounting screw for ovens, ranges, and microwaves. Secures panels, brackets, and internal components. Replace if stripped, missing, or damaged.