Bosch Range PSB326B20E Parts

Replace your gas cooktop burner cap if flames are uneven or heat isn't distributing properly. Fits specific Bosch models. Easy 5-minute swap.

Burner won't stay lit after releasing the knob? The thermocouple senses pilot flame and controls gas flow. Direct replacement part for cooktops.

Retaining washer secures burner components on your cooktop. Replace if washer is missing, cracked, or worn to ensure proper assembly and stability.

Replace worn or cracked rubber gasket to restore watertight seal and prevent leaks. Maintains proper operation by sealing compartment edges. Verify fit.

This sealing gasket creates a watertight and airtight barrier to prevent leaks and maintain proper appliance performance. It replaces a worn or damaged seal to help stop water, steam, or air from escaping. What it does

• Forms a protective seal around the door/opening to prevent water or air leaks
• Restores proper pressure and temperature retention for efficient operation
• Helps stop common leak-related symptoms like puddling beneath the appliance or visible escaping steam
• Reduces strain on pumps and heaters caused by loss of seal integrity

• One sealing gasket as shown

• Disconnect power and shut off water supply before starting work
• Remove the old seal completely and clean the mounting surface before installing the new gasket
• Press the seal evenly into the channel; avoid sharp tools or adhesives unless OEM instructions require them

This holder is a mounting component used to secure the cooktop or internal parts within a range or oven. It provides structural support and keeps components properly aligned during operation. Replace this holder if it is cracked, bent, or missing, which can cause loose-fitting parts or rattling noises.

Replace your cooktop burner seal when you notice gas leaks, uneven flames, or visible wear. Ensures proper burner operation and safety. Verify fit with your model.

This replacement nut secures appliance components to keep assemblies tight and stable during use. It restores proper fastening where a worn, corroded, or missing nut causes loose parts or noise. What it does:

• Secures mounting studs, shafts, or fasteners to prevent components from shifting
• Restores clamping force lost from stripped or corroded hardware
• Helps stop vibration-related noise and rattling from loose assemblies
• Suitable wherever the original nut was used to hold parts in place

• Disconnect power and water before starting any repair
• Use the correct socket or wrench to avoid rounding the nut
• Thread carefully to avoid cross-threading; do not force a misaligned nut
• Replace any damaged mating hardware to ensure a secure fit