Bosch Dishwasher SHV53CM3N Parts

Cutlery basket frame for Bosch dishwashers. Organizes and supports forks, knives, and spoons. Replace if cracked, broken, or damaged from wear.

Replace your dishwasher's upper rack pull-out rail assembly. Installs on top rack to enable smooth sliding. Needed when rails are cracked, broken, or wheels are worn. Includes left and right sides.

Does your dishwasher shake or make loud noises during the wash cycle? A worn suspension damper may be the cause. This part absorbs vibration and stabilizes the tub.

Insulating strip shields dishwasher wiring from heat and abrasion. Replace if frayed, brittle, or damaged to prevent electrical hazards. Confirm fit.

Molded insulation panel that separates and protects internal dishwasher components. Replaces damaged, cracked, or missing insulation panels.

Protective cover for dishwasher interior components. Replaces cracked, broken, or missing covers. Shields internal parts from water and debris.

Insulating protection shield for dishwasher interior. Replaces cracked, damaged, or missing shields that protect internal components. Direct fit part.

This pre-programmed control module replaces the dishwasher's main electronic controller to restore normal cycle selection and operation. It arrives ready to install so the appliance can recognize settings and communicate with front-panel controls. What it does:

• Manages electronic cycle selection, timing, and key control inputs for proper dishwasher operation
• Communicates with sensors and user interface to start, advance, and end wash cycles
• Can resolve symptoms like no response from controls, cycles not advancing, or inconsistent operation
• Clears control-related error indications when installed in a compatible appliance

• Disconnect power to the appliance before starting any work to avoid shock or damage
• Handle the module with care; avoid static discharge and rough handling of connectors
• Verify connector orientation and seating before restoring power; follow OEM wiring placement

This door seal strip replaces a worn or damaged trim strip that helps maintain a tidy seal and finish around the appliance door. It restores proper edge protection and helps reduce air gaps and debris intrusion at the door perimeter. What it does

• Replaces a damaged or torn door trim strip to restore a continuous seal edge.
• Helps reduce air leakage and prevents dirt or moisture from collecting at the door edge.
• Improves door alignment appearance and reduces rattling caused by loose trim.
• Useful when the existing strip is cracked, missing sections, or peeling away.

• One door seal strip (part number 11004917).

• Basic trimming or adhesive may be required depending on model; follow OEM instructions.
• Disconnect power to the appliance before starting work and keep the area dry.
• Use protective gloves to avoid sharp edges on the door during removal/installation.