Gaggenau Dishwasher GM925710 Parts

If your dishwasher detergent dispenser won't open during the wash cycle, this actuator lever assembly with springs restores mechanical movement.

Dishwasher won't start when door closes? This magnetic reed switch detects door position and signals the control. Simple 15-minute DIY replacement.

Exterior trim cover that snaps over your dishwasher door latch. Replace if cracked, broken, or missing to restore a finished look and protect the mechanism.

Seals the pump heater assembly to prevent leaks in your dishwasher. Replace if you notice water pooling or heating issues. Confirm fit with your model.

Left hinge cap for dishwasher door assembly. Replaces cracked, broken, or missing hinge caps. Cosmetic and structural part for door hinge cover.

This decorative cover conceals the upper door hinge mechanism on the right side of dishwashers. Replace when the cover is cracked, discolored, or missing, affecting the appliance's appearance.

Replacement adjuster socket for dishwasher leveling feet. Installs at cabinet base to raise or lower the unit for level installation. Replace if cracked or stripped.

Fix detergent door that won't open or latch properly. This dispenser plunger actuator restores mechanical engagement between the lid and release mechanism.

Fix corrosion or electrical issues caused by water damage. This moisture shield protects internal components from condensation. Simple DIY repair.

Leaking during wash cycles or poor drainage? This dishwasher water tube routes water between internal components. Repairs damaged tubes causing leaks.

Inner door insulation that installs inside your dishwasher door. Replace if cracked, worn, or missing to restore thermal performance and heat retention.

This turbidity sensor detects how clear the dishwasher's wash water is so the control can adjust cycle time, rinses, and water changes. Replacing a faulty sensor helps restore proper cleaning performance and normal cycle lengths.

• Monitors soil level/clarity of the wash water
• Signals the control to extend or shorten wash and rinse phases as needed
• Helps optimize water use while maintaining cleaning results
• Failure symptoms can include unusually long or short cycles, poor cleaning, repeated draining/refilling, or cycles that won't advance

• Disconnect power and turn off the water supply before servicing
• Pull the dishwasher out as needed; access the sensor from the base area
• Place a towel to catch residual water; release the locking tab or twist-lock, unplug the connector, and install the new sensor fully seated and locked
• Restore power/water and run a test cycle; check for leaks

This bottom cover sheet provides protection and insulation for the underside of your appliance while creating a finished appearance. It shields internal components from dust, moisture, and damage while helping to contain heat or cold within the unit. Replace this cover if it's torn, missing, or damaged, which can reduce energy efficiency and expose sensitive components to contamination.