Kenmore Washer 110.44934202 (11044934202, 110 44934202) Parts

Factory mounting screw secures panels, brackets, hinges, and covers on your washer. Replace missing, stripped, or rusted screws to restore secure fit.

This hose clamp secures a rubber or plastic hose to its fitting to maintain a tight, leak-resistant seal. Replace a worn or missing clamp to stop drips and keep appliance water connections secure.

• Fastens a hose to a barb or port to prevent leak
  This part fixes the following symptoms

  • Leaking

  See more...
  Do-It-Yourself Stories from Customers like You Leaking bleach tube   Mike C. • Willow Grove , PA • May 21, 2017

  Replaced the tube and the clamp Read more

This replacement screw secures appliance components and panels so they stay aligned and rattle-free during operation. Replace stripped, missing, or corroded hardware to restore a tight fit and dependable performance. What it does

• Fastens bracket
  Do-It-Yourself Stories from Customers like You My washer would not drain or start washing   Marylue B. • Georgetown Township , MI • June 09, 2017

  Ordered parts and hubby replaced and now it works. Thanks. Read more

Fix soap or softener not dispensing at the right time with this washer dispenser switch. Solves detergent drawer timing issues. Simple DIY repair.

Secures hoses to fittings to prevent leaks and blow-offs. Replace if rusted, stripped, or loose to restore a tight seal. Verify fit with your model.

Extends the drain hose approximately 4 feet. You must also order a drain hose connector kit: 285835.

This factory fastener secures appliance panels, brackets, and internal components so everything stays aligned and quiet. Replacing a missing or damaged screw restores a tight fit and helps reduce vibration, rattles, and wear.

• Fastens metal or pl
  Do-It-Yourself Stories from Customers like You Broken oven door handle   Kari M. • Greensburg , IN • December 10, 2021

  The plastic piece on the handle where the screw goes in to hold glass door up had broke. I ordered new handle, the retainer pieces that go over the plastic pieces to lock it all in and screws that were suggested. The screws were the wrong ones. They were way too small. I already had one screw and thankfully only had to buy 1 new one because the screw was $40 and shipping’s $10 for it AND it’s on back order right now. The old retainer ring that goes over plastic piece was a nightmare to remove... Read more

Front counterweight that mounts to the washer's outer tub. Replace if cracked, broken, or missing to restore proper balance and reduce vibration during spin.

Fix a washer that fills when off or leaks at the inlet valve with this L-shaped flowmeter hose. Connects water inlet to flow sensor. Easy 30-minute repair.

Touch-up paint for appliances. Covers chips, scratches, and worn areas on range tops, refrigerators, and other appliances. Includes brush applicator.

This RFI noise filter conditions the AC power entering your microwave, reducing electrical interference and helping protect and stabilize the control and power circuits. Replace it if the unit is dead or trips a breaker when starting.

• Filters ra

Washer won't start or shows electrical faults? A failed ground switch disrupts the safety circuit. This switch restores proper grounding for reliable operation.

Detergent not dispensing into drum? This dispenser to tub hose carries detergent from the dispenser to the washer tub. Moderate DIY repair.

Washer won't spin or makes noise? This retaining nut secures pump and motor components. Common cause of leaks and wobbling. Basic tools needed.

Includes water temperature sensor.

This drawer hook is the retainer that keeps an appliance drawer securely seated while still allowing easy release for cleaning or service. Replacing a worn or broken hook restores smooth, reliable drawer operation.

• Secures the drawer in its hous
  Do-It-Yourself Stories from Customers like You Replace control panel   Eric W. • Fenton , MO • October 24, 2015

  Remove top of washer and screws from panel remove and replace. Read more