Kenmore Dryer 110.78097701 (11078097701, 110 78097701) Parts

This drum baffle restores proper fabric tumbling and gentle movement inside the dryer drum for more even drying and fewer snags. It fits the drum to help lift and separate items during the cycle. What it does:

• Lifts and guides clothes as the drum rotates to promote consistent tumbling
• Reduces fabric bunching and helps improve air exposure for more even drying
• Prevents garments from riding on the drum seam and reduces rubbing/snags
• Can stop or reduce thumping or uneven tumbling when a worn baffle is the cause

• One drum baffle

• Disconnect power before beginning work
• Installation typically requires opening the dryer's front or top panel and rotating/removing the drum—follow your model's service manual
• Keep track of fasteners and note baffle orientation; replace any damaged clips or screws
• Wear gloves and eye protection; watch for sharp edges and pinch points during reassembly

This cable tie secures wiring and the power cord to the appliance chassis to help prevent chafing, pinching, or loose connections. Simple, low-cost part that restores proper wire routing and strain relief. What it does

• Holds wiring and harnesses in place to prevent rubbing against sharp edges
• Helps reduce risk of intermittent power or connector strain caused by loose wires
• Keeps harnesses routed for correct clearance and component access
• Useful during repairs to restore original wire routing and strain relief

• One cable tie (wire harness retainer)

• Safety first: disconnect the appliance from power before inspecting or replacing wiring components
• Remove the damaged or existing retainer and route harnesses to match original OEM routing before installing the new tie
• Trim excess tie tail; do not overtighten—secure, but avoid crushing wires
• Replace any tie that's melted, cracked, or otherwise damaged rather than reusing it

This electronic control board replaces the appliance's main control module to restore responsive controls and programmed cycles. It provides the unit's electronic command and timing functions so cycles start, run, and complete as designed. What it does:

• Receives input from user controls and sensors and directs power to components accordingly
• Manages cycle selection, timing, and electronic functions to ensure correct operation
• Can resolve symptoms like unresponsive touch/knob controls, failure to start cycles, or erratic cycle behavior
• Replaces a faulty or damaged control board to restore normal electronic control

• Disconnect power (unplug or shut off breaker) before accessing or replacing the control board
• Handle the board by its edges and avoid static discharge; use an ESD strap if available
• Follow OEM disassembly order for the console/frame to avoid damaging connectors or trim
• Secure all harnesses before reassembling and restoring power