Kenmore Range Hood 233.5548090 (2335548090, 233 5548090) Parts

This replacement knob restores a clean look and reliable control of your unit's settings. It fits onto the control shaft to give you a secure, easy-to-grip dial when the original knob is cracked, loose, or missing.

• Press-fits onto a control shaft to operate the switch or speed control
• Provides a secure grip for selecting settings as intended
• Replaces damaged, cracked, or missing knobs
• Helps address slipping, free-spinning, or hard-to-turn controls

• Disconnect power to the appliance before servicing
• Pull the old knob straight off; avoid prying against the panel to prevent damage
• Align the flat/D-shaped insert with the shaft and press on until fully seated
• Restore power and test operation

This wheel is the blower fan replacement that restores proper airflow in compatible Broan ventilation units. It helps re-establish efficient exhaust and reduces noise or vibration caused by a damaged or worn wheel. What it does:

• Spins on the motor shaft to move air through the vent or range hood
• Restores airflow when a cracked, clogged, or warped wheel reduces performance
• Helps reduce rubbing noises and vibration from a bent or loose wheel
• Supports normal ventilation and odor removal when operating correctly

• Disconnect power to the appliance before servicing to avoid electrical shock
• Handle the wheel carefully; edges and nearby sheet metal can be sharp
• Inspect the motor shaft, set screw, and housing for damage before installing
• Tighten mounting hardware to OEM torque and verify the wheel spins freely without rubbing

Includes two filters

A replacement rocker-style switch that restores on/off control for range hood lights or fans, helping fix loss of power or intermittent operation. Simple direct-fit design for easy swap-out and reliable everyday use. What it does

• Provides on/off control for hood lights or blower motors where the original rocker switch failed
• Replaces a worn, stuck, or non-responsive rocker to restore consistent power
• Commonly used when lights won't turn on, fan won't start, or operation is intermittent
• Handles user input with a tactile rocker action for straightforward operation

• One rocker-style switch

• Disconnect power to the appliance at the breaker before servicing
• Remove the hood/light housing per the appliance service instructions to access the switch
• Note wire locations or take a photo before disconnecting leads to ensure correct reconnection

This is a replacement mounting nut used to secure components and hardware in range hoods and ventilation assemblies. It provides a simple, reliable fastener to hold studs, bolts, or threaded posts in place. What it does:

• Secures panels, mounting brackets, or trim pieces to threaded studs or bolts
• Helps keep components aligned and prevents parts from slipping loose
• Can be used where a small, standard nut is required for assembly or repair
• Commonly replaced when stripped, corroded, or missing to restore safe attachment

• Disconnect power to the appliance and ensure the area is safe before servicing
• Match nut to the correct stud/bolt thread size and pitch before installation
• Tighten with the appropriately sized wrench; avoid over-tightening which can strip threads
• Replace any damaged mating hardware for a secure fit