Kenmore Dehumidifier 580.54701800 (58054701800, 580 54701800) Parts

Dehumidifier not removing moisture or running hot? A worn turbo fan blade disrupts airflow, reducing dehumidification. Direct-fit assembly restores circulation.

This overload protector is a small safety device attached to the compressor that shuts off power if the compressor draws too much current or overheats. It helps prevent damage to the compressor motor. Replace it if the dehumidifier or air conditioner compressor won't start, cycles on and off rapidly, or clicks but fails to run.

Replace the decorative escutcheon trim on your dehumidifier's control panel. This trim piece covers gaps and provides a finished look when original is cracked or missing.

Replace your dehumidifier's damaged or frayed power cord. Restores electrical connection when the original cord is broken, cracked, or missing.

This replacement shroud assembly directs airflow and protects internal components, helping restore proper ventilation and reduce strain on the blower and motor. It's a direct-fit replacement when the original shroud is cracked, warped, or missing. What it does:

• Channels exhaust air from the drum/blower to the vent, improving airflow and drying efficiency
• Protects the blower, motor, and wiring from lint and debris
• Helps prevent rubbing or interference between moving parts that can cause noise or wear
• Can address symptoms such as reduced drying performance, unusual rattling, or visible damage to the shroud area

• One shroud assembly

• Disconnect power (and gas supply for gas models) before beginning any service
• Installation typically requires removing the dryer front or rear access panel; follow the manufacturer service manual for your model
• Handle edges carefully to avoid damage and ensure proper alignment to mating components