Kenmore Wall Oven 790.40432800 (79040432800, 790 40432800) Parts

Adhesive seal tape restores tight door seals on ovens, reducing air leaks and improving temperature control. Replace when worn or damaged. Confirm fit.

Replacement spacer for oven doors. Maintains proper door alignment and spacing. Replace if cracked, broken, or missing to ensure correct door fit.

Wire junction box assembly for wall ovens. Houses and protects electrical connections. Replace if cracked, damaged, or missing to properly enclose wiring.

Oven door trim piece that frames the door window. Replace if your existing trim is cracked, broken, discolored, or missing to restore appearance.

Secures the rear control panel to your oven for a stable, flush fit. Replace if the original bracket is bent, broken, or missing to eliminate panel movement.

Left-side backguard support bracket secures the backguard to your oven frame. Replace if bracket is cracked, broken, or missing to restore stability.

This part has been discontinued by the manufacturer and is no longer available.

Decorative trim piece for wall ovens. Replaces cracked, chipped, or missing trim around the oven frame. Restores the finished look of your appliance.

This replacement trim piece restores the finished look around the refrigerator door or cabinet edge and helps cover gaps, screw heads and worn edges for a cleaner appearance. What it does:

• Covers exposed edges and screw holes for a finished exterior
• Hides minor cosmetic damage around the door or cabinet opening
• Helps retain proper gasket seating by closing small gaps near the seal area
• Restores factory appearance after repair or component replacement

• Install with the refrigerator unplugged and doors supported to prevent movement.
• Remove any old adhesive or fasteners and align trim carefully before fastening.
• Use manufacturer-recommended fasteners or adhesive; do not overtighten screws.

This back-side wrapper is the outer rear panel that covers and protects the appliance's rear components while restoring the unit's finished appearance. It helps keep wiring and parts shielded from dust and incidental contact. What it does:

• Covers the appliance's rear area to protect wiring and components from dust and damage
• Restores a finished exterior surface for a neat appearance
• Helps reduce incidental contact with internal parts during normal use
• Can stop minor drafts or air movement that occur through a damaged or missing rear wrapper

• Disconnect power to the appliance before beginning any service
• Remove access panels or mounting clips as required to reach the rear wrapper
• Use basic hand tools; support the panel during removal/installation to avoid scratching adjacent surfaces