Kenmore Wall Oven 790.40453802 (79040453802, 790 40453802) Parts

Secures the rear control panel to your oven for a stable, flush fit. Replace if the original bracket is bent, broken, or missing to eliminate panel movement.

Left-side backguard support bracket secures the backguard to your oven frame. Replace if bracket is cracked, broken, or missing to restore stability.

Replacement endcap for your oven. This trim piece installs on the control panel or frame to cover exposed edges. Order a new cap if yours is cracked or missing.

Mounting screw for range installations. Secures panels, brackets, or components. Replace if stripped, missing, or corroded during repairs or reassembly.

This part has been discontinued by the manufacturer and is no longer available.

This replacement trim piece restores the finished look around the refrigerator door or cabinet edge and helps cover gaps, screw heads and worn edges for a cleaner appearance. What it does:

• Covers exposed edges and screw holes for a finished exterior
• Hides minor cosmetic damage around the door or cabinet opening
• Helps retain proper gasket seating by closing small gaps near the seal area
• Restores factory appearance after repair or component replacement

• Install with the refrigerator unplugged and doors supported to prevent movement.
• Remove any old adhesive or fasteners and align trim carefully before fastening.
• Use manufacturer-recommended fasteners or adhesive; do not overtighten screws.

Replace cracked, broken, or damaged outer door glass on your wall oven. This transparent panel installs on the front of the oven door assembly.

This back-side wrapper is the outer rear panel that covers and protects the appliance's rear components while restoring the unit's finished appearance. It helps keep wiring and parts shielded from dust and incidental contact. What it does:

• Covers the appliance's rear area to protect wiring and components from dust and damage
• Restores a finished exterior surface for a neat appearance
• Helps reduce incidental contact with internal parts during normal use
• Can stop minor drafts or air movement that occur through a damaged or missing rear wrapper

• Disconnect power to the appliance before beginning any service
• Remove access panels or mounting clips as required to reach the rear wrapper
• Use basic hand tools; support the panel during removal/installation to avoid scratching adjacent surfaces