Kenmore Wall Oven 790.40522402 (79040522402, 790 40522402) Parts

This adhesive seal tape is a replacement sealing strip used to restore a tight seal on appliance doors and panels, helping reduce air leaks and improve temperature control. It's a simple repair for worn or damaged seal edges. What it does:

• Provides a flexible, adhesive sealing surface to close gaps between door/panel and cabinet
• Helps reduce air or moisture leakage that can cause temperature loss or inefficient operation
• Restores worn or deteriorated sealing surfaces without replacing the entire gasket
• Compatible with applications where a narrow adhesive sealing strip is required

• Clean and dry the mounting surface thoroughly before applying for best adhesion
• Measure and trim the tape to fit; press firmly along the full length to ensure contact
• Allow adhesive to set per ambient conditions before closing the door or returning to service

This is a 10-24 x 1/2 inch machine screw used to secure temperature probes, thermistor brackets, shields and drawer/box components. It provides a simple, reliable fastener for small appliance assemblies. What it does:

• Secures probe or thermistor brackets to the appliance chassis or housing
• Holds shielding or small drawer/box parts in place to prevent movement or rattling
• Helps maintain correct sensor positioning so temperature readings stay stable
• Common replacement when a stripped, corroded, or missing screw causes loose parts or vibration

• One 10-24 x 1/2 in. screw

• Use the matching 10-24 threaded hole; avoid over-tightening to prevent stripping or cracking nearby plastic
• If replacing a corroded screw, inspect mating threads and components for damage before reuse
• Turn off and unplug the appliance or disconnect power before accessing internal components

This element hanger support secures a cooktop surface heating element to the range and keeps the element aligned for reliable contact and stable cooking. Replaces a worn or bent bracket to restore proper element positioning. What it does:

• Holds the surface heating element in the correct position under the cooktop
• Stabilizes the element to maintain solid electrical contact and even heating
• Helps prevent element wobble, arcing, or intermittent power to the burner
• Fits where the element connects to the terminal/anchor point on the cooktop

• 1 element hanger support bracket

• Disconnect power to the appliance before attempting any service
• Remove the cooktop or element as required to access the hanger; follow OEM disassembly steps
• Inspect element terminals and surrounding parts for damage while replacing the bracket

This part has been discontinued by the manufacturer and is no longer available.

This wiring diagram is the original OEM schematic sheet that shows the appliance's electrical circuits in plain terms to help identify component connections and trace power paths for troubleshooting. What it does:

• Shows wire colors, connector locations and circuit routing so you can locate and identify electrical components.
• Helps diagnose symptoms like intermittent power, no power to controls, blown fuses or tripped breakers by tracing the affected circuit.
• Clarifies control board, motor, heater and sensor wiring relationships to reduce guesswork during repairs.
• Useful when replacing harnesses or verifying proper reassembly after service.

• One wiring diagram (schematic sheet) as shipped by the manufacturer.

• Always disconnect power to the appliance before inspecting or using the diagram to work on electrical components.
• This is a reference document only; follow all safety procedures and manufacturer service instructions when repairing.
• Handle the sheet carefully—store with the appliance model paperwork for future troubleshooting or use.