Kenmore Range 790.78302011 (79078302011, 790 78302011) Parts

This convection fan element mounts on the oven's rear wall around the blower. It supplies supplemental electric heat so the fan can circulate hot air evenly during convection modes for more consistent baking and roasting.

• Provides heat directly around the convection fan to help maintain even temperature during convection cycles
• Failure can cause poor browning, uneven results on multiple racks, or convection modes that run without proper heating
• May show visible breaks, blistering, or burnt spots; an open element will fail a continuity check
• If standard bake heats normally but convection bake does not, this element may be at fault

• Disconnect power at the breaker and allow the oven to cool completely before servicing
• Remove oven racks and the rear interior panel to access the element surrounding the fan
• Note wire positions; transfer any spacers or mounting hardware from the original element as needed
• Secure the element without bending it and confirm the fan spins freely with proper clearance

This cabinet insulation helps reduce heat transfer inside the refrigerator, supporting stable temperatures and efficient cooling. Replacing damaged or missing insulation can improve temperature control and reduce frost buildup. What it does:

• Fills gaps between the cabinet and liner to slow heat transfer and maintain internal cold
• Helps the appliance reach and hold set temperatures more consistently
• Reduces condensation and excess frost on interior surfaces
• Can improve compressor run-time and overall energy efficiency when intact

• Disconnect power before starting
• Remove food and shelving from the compartment before accessing the insulation
• Handle insulation carefully to avoid tearing; secure per manufacturer routing and adhesive points
• Dispose of old insulation per local regulations

This inner oven door glass replaces a cracked, broken or fogged inner door panel to restore thermal performance and visibility into the oven cavity. It helps keep heat in the oven and prevents direct exposure to the internal cavity. What it does:

• Replaces damaged or cracked inner oven door glass that can compromise heating and safety
• Restores the oven door's insulating layer to reduce heat loss and improve cooking consistency
• Provides a clear viewing window to check food without opening the door
• Stops rattling or vibration caused by loose or broken glass

• Disconnect power to the appliance and ensure the oven is completely cool before starting
• Wear cut-resistant gloves and eye protection when handling glass to avoid injury
• Some installations require removing the oven door and disassembling door screws or clips; keep fasteners organized

This trim piece finishes the appliance door opening and restores a clean, finished appearance. It covers the edge of the door/frame to improve looks and help prevent gaps where dirt could collect. What it does

• Replaces cracked, chipped, or missing decorative trim along the door or frame
• Restores a smooth, finished edge and consistent appearance after damage or disassembly
• Helps reduce dust and debris buildup in the gap between the door and cabinet
• Prevents sharp or jagged edges where the original trim is broken

• One replacement trim piece as shown

• High-level, no-specialty tool install; typically snaps or screws into place—keep original fasteners when possible
• Power off and unplug the appliance and ensure the door is supported before removing or installing trim
• Handle edges carefully; wear gloves if trim is damaged to avoid injury
• If fasteners or clips are missing/damaged, replace them with manufacturer-recommended hardware

This thermo disc is a small temperature-sensing switch that helps monitor and control appliance temperatures to protect components and support proper operation. It fits into the appliance's temperature circuit and responds at a designed trip point. What it does

• Senses temperature and opens or closes an electrical circuit at its rated trip point
• Helps prevent overheating by interrupting power when temperatures exceed the design threshold
• Supports proper temperature control for timed cycles or safety systems
• Commonly used in temperature-regulation and safety applications inside appliances

• One thermo disc

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Replace only with the exact part number for proper function and safety
• Handle the disc carefully; avoid bending or damaging the sensing element or terminals