Kenmore Washer 796.29472000 (79629472000, 796 29472000) Parts

Fix exposed fasteners or openings on your washer dispenser with this protective cover cap. Keeps dirt and moisture out while restoring a clean finish.

Secures internal components to the washer frame. Replace if your bracket is cracked, rusted, broken, or missing to restore stable support and alignment.

Fix detergent not dispensing or leaking from the drawer. This washer dispenser assembly replaces cracked or clogged units. Direct-fit installation.

Secures internal washer components in proper alignment. Replace this mounting bracket if cracked, rusted, broken, or missing to restore stability.

Connects the washer's inner drum to the drive assembly. Replace if cracked, damaged, or worn to restore drum stability and eliminate wobbling or noise.

Replace your washer's control panel housing case if cracked, broken, or damaged. This protective cover secures and shields internal components.

This replacement holder secures a small appliance component in place to restore proper alignment and reduce vibration. It's a direct-fit bracket designed to hold components steady and prevent movement that can cause noise or malfunction. What it does:

• Keeps the associated component firmly mounted to its chassis or support
• Prevents rattling, misalignment, or intermittent contact caused by a damaged or missing holder
• Helps maintain proper operation of the component it supports
• Common symptoms: visible crack or break in the holder, loose or shifting component, or new noise from the area

• One replacement holder as shown

• Disconnect power and/or water supply before beginning any repair
• Inspect surrounding parts for damage before installing the new holder
• Basic hand tools are typically required; avoid overtightening fasteners

This holder is a small mounting bracket that secures internal components in place, helping prevent movement and vibration for reliable operation. It's a simple replacement part that restores proper fit and stability. What it does:

• Secures and supports nearby components or assemblies to prevent shifting
• Reduces vibration and rattling that can cause noise or wear
• Helps maintain correct alignment for connected parts to operate smoothly
• Restores original component retention after damage or loss of the bracket

• Disconnect power to the appliance before beginning any repair
• Basic hand tools may be required; handle small parts carefully to avoid loss
• Inspect surrounding clips and fasteners; replace any that are damaged

Rear cover panel for your washer cabinet. Replaces cracked, broken, or missing rear covers that expose internal components or create gaps in the exterior.

Secures washer components in place. Replace if loose, broken, or missing to prevent rattling and part displacement. Verify fit with your model number.

This heater assembly replaces the dryer's heating element and housing to restore warm airflow for drying cycles. It's a direct-replacement assembly that re-establishes the appliance's heat source when the dryer won't heat properly. What it does:

• Houses the electric heating element that produces heat for drying cycles
• Replaces a burned-out element, open circuit, or damaged housing that can stop the dryer from heating
• Helps resolve symptoms such as no heat, only air tumbling, or weak/partial heating
• Works with the dryer's blower and thermostat to deliver consistent drying temperatures

• One heater assembly (heating element installed in housing)

• Disconnect power to the dryer (unplug or shut off breaker) before servicing
• Allow components to cool and wear gloves to protect hands from sharp edges
• Verify the part number matches the dryer's parts list before installation

Fix detergent not dispensing or a cracked drawer with this washer detergent dispenser. Slides out for easy replacement in most front-load models.

Washer tub cover assembly that sits on top of the outer tub. Replace if your original cover is cracked, broken, or missing to restore proper coverage.

Seals the fabric softener dispenser and directs liquid into the washer during rinse. Replace if cracked, warped, or missing to prevent leaks.

Leaking detergent or clogged dispenser? Replace the drawer housing to restore proper detergent flow and eliminate leaks. Straightforward DIY fix.