Thermador Microwave Oven Combo CM302US Parts

90-degree connector cable for ovens and cooktops. Replaces damaged, frayed, or missing connectors. Essential for secure electrical connections.

Mounting bracket that secures the convection motor inside your oven cavity. Replace if cracked, bent, or missing to properly support the motor assembly.

Oven door won't close or stay shut? This door strike latch engages the catch to keep your oven door secure. Simple fix for worn latches.

Oven not heating evenly in convection mode? This rear convection heating element restores proper temperature. DIY-friendly, typically installs in 10-20 minutes.

Replacement mounting nut for securing internal oven and range components. Needed when original fastener is stripped, missing, or damaged during repair work.

This is a high voltage capacitor used in the electronic control or microwave cooking section of a range or oven. It stores and releases electrical energy to help power components that require high voltage. Replace this capacitor if the oven or range displays error codes, fails to heat properly, or if the control board is malfunctioning due to a faulty capacitor.

A small chassis knockout protector that shields wiring and components where factory knockout holes are removed. Helps prevent wire abrasion and keeps openings tidy for safe appliance operation. What it does:

• Fits into a chassis knockout to protect wiring from sharp sheet-metal edges
• Helps prevent cable chafing and short circuits by covering exposed openings
• Keeps out debris while allowing routed harnesses to pass through the cabinet
• Commonly used where service or modifications require a sealed knockout

• One chassis knockout protector

• Install by pressing the protector into the knockout until it seats securely
• Ensure wiring is routed through the protector and not pinched between metal edges
• Disconnect power before servicing appliance to avoid shock or injury

Flexible conduit cable that protects electrical wiring in your oven. Replaces cracked, damaged, or worn conduit. Installs between junction box and unit.