Thermador Range DP364GECC Parts

Replace your cracked or faded control panel insert trim to restore appearance and proper button alignment. Fits into the control area for a clean look.

This is the bake element located at the bottom of the oven cavity, responsible for producing the heat needed for baking and roasting. It is a looped resistive coil that heats up when energized by the oven's control system. Replace this element if the oven is not heating, heating unevenly, or if the element shows visible damage such as cracks, blistering, or burn-through spots.

Small hardware pin that secures or pivots components in gas ranges and cooktops. Replace if worn, missing, or broken to restore proper alignment.

If your burner won't light or gas flow is weak, this valve controls fuel delivery to each burner. Moderate difficulty repair, typically 30-60 minutes.

This electronic PC board is the appliance's main control, processing inputs and directing power to components so cycles run correctly. Replacing a failed board can restore normal operation when the unit is dead, won't start, or stops mid-cycle.

• Interprets user inputs and sensor feedback to execute programmed cycles
• Switches relays to power motors, valves, heaters, and other loads as required
• Manages timing, temperature, and safety logic for consistent performance
• Typical failure symptoms: no power/won't start, unresponsive or erratic controls, cycles ending prematurely, recurring error codes

• Disconnect power before servicing; verify power is off with a meter
• Use ESD protection; handle the board by the edges to avoid static damage
• Move connectors one at a time to identical positions on the new board to prevent miswiring
• Some models require service-mode setup or calibration after installation—follow your model's service documentation

Protects your range's blower assembly and directs airflow for proper ventilation. Replace if cracked, damaged, or airflow is restricted. Verify fit.

Gas range fixing kit secures components and prevents rattling or loosening. Replace when parts become loose or unstable. Verify fit with your model number.