Kent January 12, 2020 for Model Number Bosch SHE3AR52UC/18 I have had this dishwasher about five years. There was a local lightning strike a few days ago. Since then, the lights on the control panel just blinked. I turned the unit off and back on again (and reset the breaker) and now the "Rinse Aid" light just flashes. No other button press or combination does anything -- just that light. I filled the rinsing agent dispenser just to see if that would help but it does not. Is this repairable economically?
1 Answer Kent, This issue sounds like the control unit on the machine has been damaged and would need to be replaced. Read More...
Gus July 12, 2019 for Model Number SHE3AR52UC/08 Upon starting the machine it goes right to "clean" after a few minutes, long before the cycle is complete and there's still water in the bottom because the clean cycle has not finished. Will part 00705306, if replaced, solve this problem? Thank you.
1 Answer Gus, For this issue, the most likely cause will be the control unit which will be part number 00705306. Read More...
Thomas May 23, 2019 for Model Number she3ar75uc/12 E25 error code. Have checked all hoses and replaced drain pump. Still get error code if try to run a wash cycle. If I cancel the cycle dishwasher will drain properly.
1 Answer Thomas, as the drain pump is new and the hoses have been cleared, the most likely possibility is that the main control is not properly sensing the return voltage from the drain pump. Read More...
Xuesheng Y. February 14, 2019 for Model Number SHE3AR55UC/08 Bosch dishwasher detergent residue in the dispenser. Dispenser opened after finished washing, but detergent looks like didn't be used at all. I opened the door in 15 minutes after starting, the dispenser didn't open. When should the dispenser open in this model? Also why I manually opened the dispenser in 1 minute of cycle began, but the residue still there after finished washing? Thanks
1 Answer Hello Xuesheng, This is either going to be caused by a low water fill of a lack of water circulation. You should fill the unit and make sure there is water visible in the bottom and check the filters to be sure none are clogged. There is a fine filter that should be cleaned out periodically or water circulation will be hampered. If these are clear, make sure the gaskets at the feed tube that supplies water for the center spray arm are present and intact. You may need to replace the water valve in the case of a low water fill and you may need to disassemble the pump assembly to verify the impeller is operating properly. Read More...
Stephen November 12, 2018 for Model Number SHE3AR56UC/12 FD930402964 Dishwasher will start sometimes and run a complete cycle. It sometimes starts and only runs for a few minutes like it is ending a cycle then the clean light comes on- dishes have not been cleaned unit has not cycled. We can leave it alone or someone else can hit the button and it will decide to work. Any idea what is causing this or how to test to see what the problem is and how to fix it. The unit is 2-3 years old I think. Thanks, Stephen
1 Answer Stephen, With the symptoms stated this issue would most likely be caused by a faulty control unit on the unit. Read More...
Bill January 22, 2018 for Model Number SHE3AR52UC/07 The control panel may not be good. The control is stuck on auto wash an active and will not shut off should the control panel be defective?
1 Answer Bill, This issue would most likely be caused by the control unit which is part number 00705306. Read More...
Richard April 09, 2016 for Model Number SHE3AR56UC/18 Where would I find the programming method/code required when I replace the control board on my bosch dishwasher -part no 00705306
1 Answer Richard, If there is programming needed to the board when it is replaced then there should be a service sheet that comes with the part to tell you how to do this. Read More...