Darren October 15, 2023 for Model Number SHXM98W75N/01 Dishwasher not filling. With the fill solenoid removed from the dishwasher there is no continuity on the fill solenoid coil when measured across the terminals. Bench tested the fill solenoid with power and water, it works. If I take my voltage tick and run a cycle on the dishwasher there is constant power at the wiring harness. When the fill solenoid is in the dishwasher and you run a wash cycle there is some water going into the dishwasher. Help
1 Answer Darren, while the valve is hooked up to the dishwasher, a multimeter would need to be used to identify if the valve is receiving 120 VAC when a cycle is started. If it is receiving a partial voltage, the power control module 12016887 would need to be replaced. Read More...
Ronald June 02, 2023 for Model Number SGE68U55UC/B3 If this part was damaged, could it cause a E15 error?
1 Answer Hello Ronald, yes it can cause that code, also check the dishwasher base for water leak. Read More...
Josh June 02, 2023 for Model Number SGE53U52UC/C6 I have an E16 error. If I replace this part will it fix the error?
1 Answer Josh, this is a piece of styrofoam that trips a switch when water is present in the bottom of the plastic tray, located under the tub, It usually means there is a leak and it needs to be investigated before allowing the dishwasher to run. Read More...
Ann June 02, 2023 for Model Number DWHD440MFP/01 Is this the correct part for my model? I have a Thermador & this is a Bosch part.