Kevin June 13, 2025 for Model Number NGM8054UC-03 1 burner on Bosch stovetop continues to spark after lit. Other 4 work fine. I replaced the switch, no change. I replaced the burner which came with a new igniter (Part Number 00612817 also called ignition device on Appliance Parts Pros website), no change. I swapped the wires from the the switch to the spark module (Part Number 12004873 also called ignition device on Appliance Parts Pros site) and from the spark module to the igniter for the burner that had a problem to one that worked, and then both continued to spark after lit. Swapped the wires back, and only the original burner has problem again. I thought the last test would tell me if it was the wiring harness or the spark module but wasn't very conclusive since both burners had problem after switch. I'd greatly appreciate some advice on how to diagnose this as I already bought the new venturi set here and drilled out the old ones due to one being seized. I'd really like to get it fixed.
1 Answer Hello Kevin, thank you for contacting AppliancePartsPros.comThis may have been an issue with the switch 00627235 that has damaged the ignition device/spark module 12004873 or vice versa. This would explain why switching the wiring to another igniter made it spark continuously while the igniter that originally had the issue also continued to spark. I recommend replacing the switch for the affected burner and the spark module together. Read More...
Kim May 15, 2023 for Model Number NGM5455UC/01 None of my ignitors spark. Would the ignition device be the issue or would I need to look at something different?
Frank May 15, 2023 for Model Number NGM5455UC/01 The front right gas burner will not spark. All other burners spark and light. The right one did spark off and on for a while but no more. I changed the igniter with another one but did not help. This proved that it was not the ignitor. Do I change the spark module or the Ignitor harness?
1 Answer Frank,If you switch the ignitor wires on the spark module and it still won't spark then check for continuity on the spark switch for that specific valve that doesn't light when the knob is in the light position. If there is no continuity then the harness needs replaced not the module. Read More...
1 Answer Billy, with the gas and power supplies turned off, the burner heads, knobs, and burner top panel would need to be removed to access the ignition device. The cooktop may need to be lifted out of the counter to do this if the counter is only supporting the top burner panel. Read More...
Ted September 01, 2021 for Model Number HGIP054UC/01 Is this Ignition device the likely problem if all five burners continue sparking when one burner has lit and the knob is turned to a level where the sparking should stop?
1 Answer Ted, the ignition device 12004873 would be the most likely cause of this failure. Read More...
John June 02, 2021 for Model Number NGM8065UC/01 Do you have the cable that plugs in to the Ignition Device? There are 5 male connections on one side for the individual burners. The other side has an 11 pin connection for power and the valves (looking at the schematic). That is the cable that I can't find and does not show up on the parts diagram. The part number for the ignition device is AP5951433