Paulo March 24, 2022 for Model Number HMC80251UC/01 The connector at the magnetron melted. Does this mean the magnetron needs to be replaced?
1 Answer Paulo, The connector melting normally would be caused by heat from the connection being loose. Just replace the connector and the unit should be good. Read More...
Dewey October 13, 2019 for Model Number HMC80252UC/03 my fuse inside the microwave blows as soon as i start the microwave portion, is it the magnatron?
1 Answer Dewey, based on the information provided, the most likely cause of failure is going to be either the transformer or the capacitor. The capacitor can be tested once the unit has been unplugged for more than 10 minutes and the capacitor has discharged. The capacitor would be tested for resistance and should start at 0 ohms and slowly increase in resistance. The resistance should reach no more than 20M ohms. If the capacitor 00631397 reaches more than this, it has failed. If the capacitor does not go above the tolerance, then the transformer 00145870 would be the likely issue. Read More...
Mark August 25, 2019 for Model Number hmc80251uc/01 my door switch showed signs of getting hot(smoke) and 1 of my wires from the temp. regulator is melted. Is this caused from a faulty door switch or something else?
1 Answer Mark, the sensor 12014096 having a melted wire could cause several issues to include overheating which can in turn overwork the wiring. Both the door switch and the sensor will need to be replaced, but you may want to test all of the wiring to ensure there are no further issues as well as the heating components. Read More...