Joseph December 21, 2018 for Model Number bosch ngp945ul igniters work on all burners if you light one at a time, once one lights you cant light another burner with the igniter but can be done with lighter. all clips tight. igniter dont spark at all once one burner is on. any thoughts
1 Answer Joseph, With this issue the most likely cause for the other burners to not spark and light once one is ignited would be a faulty spark module 12004873. Read More...
Jerrydk March 10, 2017 for Model Number PRG304US When the burners are on, on the left side (xlo burners) after a short time the rear burner will go out and just spark but not light ,until I let the stove burners cool down on left side. Also if I have the rear burner on for a while and start the front one the rear will go out and just spark but not light again. Everything else works fine.
1 Answer JerryDK, This issue would most likely be caused by a faulty solenoid which is part number 00411253. Read More...
Arthur July 25, 2016 for Model Number PRG304US I have gas to all burners but only ignition on back left burner. and then sometimes (but mostly not) on the other 3. if I understand correctly the ignitor need to be fastened to the cook top securly and thus grounded to spark and ignite the gas? it seems like all my igniters are loose so that often they are not grounded and don't spark. is it common for the clips to fall off, and is there an easy way to secure these from above without having to remove nuts on all the burners and disassemble cooktop just to attach a clip...
1 Answer Arthur, It would sound like the clips may have come off the igniters but unfortunately you would need to remove the top in order to get the clips back on. Read More...
Reid October 27, 2011 for Model Number thermador profesional I cannot remove burner venturi on stove. Socket will not budge venturi. Any ideas how to unthread venturi?
1 Answer Hi Reid. Some venturi's are 10.5mm. They should loosen to the left of top view. Please send us the model # so we acn assist. Thank You. Read More...
Reid October 27, 2011 for Model Number Thermador profesional How do you remove Venturi in burner. Has a hex head but does not seem to thread on.
1 Answer Hello Reid. Yes, the venturi unscrews fromt he burner assembly. You will use a 20mm socket to remove the venturi. Hope this helps. Read More...
Reid October 26, 2011 for Model Number Thermador professional range How do you remove the burner to replace ignitor clips?
1 Answer Hello Reid. You will need to remove the venturi in the center of the burner assembly, to remove the burner and access the igniter clip 00189322. Hope this helps. Read More...