Stephen L August 06, 2013 for Model Number Magic Chef microwave model # MCM1110W The large rectangular button on the bottom right of my microwave does not go back into position easily (i.e. "pop out") when I try to close the door, and the door won't close unless the button is in position flush against the cabinet. I can get the button to get into position manipulating it manually but there is obviously an automatic mechanism that is missing. There is some kind of release mechanism (two small prongs on the door that go into two openings when you closs the door) that linked to the press/depress function of this button. My wife says that she saw a spring go sailing across the kitchen but couldn't find it. So my question is: Do I need the Bosch 0041139 spring or the Bosch 0041137 spring and how do I replace it? Thank you.
1 Answer Stephen, This is a Magic chef microwave which would not use either of the bosch springs that you listed. If the spring is missing, the spring is not available for purchase. Read More...
Jk March 29, 2012 for Model Number CMT21 Need to replace the spring on my lower oven door. How do I do this?
1 Answer Hello JK. First you will need to remove the oven door. To do this, Open the oven door and inspect the hinge assembly. By the opening on the door, you will see a latch on the hinge. Push it down until it contacts the hinge bracket at the opening on the oven frame and goes through the bracket hole below the notch. Grasp the door with both hands and raise it slightly. The latch will automatically enter the notch. Slide the door off the hinge arms by pulling outward at a slight upward angle. Now the hinges are locked open by the latches. To close the hinges, hold hinge arm down and lift the latch, then carefully raise the hinge arm. The hinges will be forcefully snap closed with out the weight of the door. To reopen the hinges, you will need to forcefully open the hinge and lock the latch into place. Next pull the oven half way out of the cabinet. Attach a wire to the door spring and pull the spring and release the cable from the spring. Make sure you note which of the three hooks on the cable the spring is attached to and use the same hook when reinstalling the spring 00411347. Hope this helps. Read More...