Mark February 06, 2023 for Model Number EIFLW50LIW1 On my electrolux washer door boot seal. It goes thru the entire cycle but on the last spin cycle the rubber boot heats up and even begins to smoke. Not sure where to start looking to fix it. There is some wear on the boot and residual rubber deposit on the drum around the rim from the boot getting worn or hot. Can you tell me where the problem may be?
1 Answer Mark,Based on the information provided I would check for excess play in the inner drum, this could be an issue with the spider assembly and/or the bearings being worn or damaged allowing the tub to rub against the front area of the outer tub. Read More...
1 Answer Hello Ed, You still have to order the door boot by model number as you would any other part of the machine. For model WF42H5200AP/A2 you would need to order DC97-18094B. Read More...
Kathy Smith November 01, 2017 for Model Number EIFLW55HIW0 Washer leaking front right side and bottom. replaced boot, but when replacing the boot the spring that held it looked stretched but was still pretty tight. Could it be that I just need to replace that spring?
1 Answer Kathy, It is possible that the spring is stretched and would need to be replaced but if it was leaking before it could have been the boot. Read More...
Tressa November 23, 2015 for Model Number ELECTROLUX EWFLS65I What part do you think I need if the washer is leaking in the back left corner only during the spin cycle?
1 Answer Hello Tressa. You will need to check the drain hose on the unit and see if it is leaking. Read More...